09-013-22
Service Bulletin Details
Public Details for: 09-013-22
Some customers may complain that the clip on the rear end of the rear beltline molding is loose and the molding is slightly lifted up. Due to the poor shape of the clip claws, the fitting force to the door body may decrease while in use. T
Models from 2021
2021 MAZDA MAZDA3 |
Models from 2020
2020 MAZDA MAZDA3 |
Models from 2019
2019 MAZDA MAZDA3 |
BULLETIN NOTES APPLICABLE MODEL(S)/VINS 2019-2021 Mazda3 (5-door HB) with VINS lower than JM1BP******401257 (produced before July 23, 2021) DESCRIPTION Some customers may complain that the clip on the rear end of the rear beltline molding is loose and the molding is slightly lifted up. Due to the poor shape of the clip claws, the fitting force to the door body may decrease while in use. To eliminate this concern, the clip has been enlarged in the horizontal direction to improve the fitting force against the door body. Customers having this concern should have their vehicle repaired using the following repair procedure. REPAIR PROCEDURE 1. Verify the customer concern. 2. Replace both the left and right side clips with the modified ones according to the following repair procedure. Required Tools: • Long nose pliers • Harness tape Page 1 of 4 05/03/2022 08:28 AM cciz a. Wrap the harness tape around the pliers to prevent scratching the body. NOTE: DO NOT wrap the tape around the tip of the pliers to allow for easy grabbing. b. Check if the rear beltline molding is unclipped or not. • If the clip is unclipped, go to step f. • If not, go to step c. c. Open the rear door, and flip the glass run channel upward from the inside of the door. Check the clip that holds the belt-line molding in place (dotted circular part). Page 2 of 4 05/03/2022 08:28 AM cciz d. Insert the pliers through the gap, pinch the clip, and push it in the direction of release. NOTE: Be careful not to damage the door body panel. e. Check if the rear beltline molding is lifted. f. Place your hand on the clip from below and remove the clip by sliding it with the opposite fingers. NOTE: When removing the clip, be careful not to pull the belt line outward more than 1.6 in (40 mm) (1) The beltline molding may be deformed permanently if the clip is pulled outward more than 1.6 in (40 mm). g. Install the modified clip in the same way as in step f (place your hand on the clip from below) and other removed parts in reverse order of removal. NOTE: Some vehicles use clips with gaskets, but there is no problem replacing them with improved ones without gaskets. 3. Verify the repair. Page 3 of 4 05/03/2022 08:28 AM cciz PARTS INFORMATION Parts Number Description Qty. Notes BEMD-72-604A Clip 2 For rear beltline molding WARRANTY INFORMATION NOTE: • This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair. • This repair will be covered under Mazda’s New Vehicle Limited Warranty term. • Additional diagnostic time cannot be claimed for this repair. Warranty Type A Symptom Code 89 Damage Code 9B Part Number Main Cause Quantity Operation Number / Labor Hours: BEMD-72-604A 2 XXT5XXRX / 0.2 Hrs. Page 4 of 4 05/03/2022 08:28 AM cciz