09-017-22
Service Bulletin Details
Public Details for: 09-017-22
Some vehicles may have rust on the contact parts between the clips (for attaching the roof molding) and the roof panel (ditches of the roof rail). This is caused by the gap between the roof molding attachment clips and the roof panel not b
Models from 2021
2021 MAZDA MAZDA3 |
Models from 2020
2020 MAZDA MAZDA3 |
Models from 2019
2019 MAZDA MAZDA3 |
BULLETIN NOTES APPLICABLE MODEL(S)/VINS 2019-2021 Mazda3 (Japan built) vehicles with VINS lower than JM1BP******507106 (produced before December 4, 2021) 2019-2021 Mazda3 (Mexico built) vehicles with VINS lower than 3MZBP******219987 (produced before December 2, 2021) DESCRIPTION Some vehicles may have rust (1) on the contact parts between the clips (for attaching the roof molding) and the roof panel (ditches of the roof rail). This is caused by the gap between the roof molding attachment clips and the roof panel not being wide enough to allow paint to be appropriately applied to the roof panel. To eliminate this concern, the shape of the roof molding clip has been changed to enable paint application between the clip’s rib and roof during the manufacturing process. Customers having this concern should have their vehicle repaired using the following repair procedure. REPAIR PROCEDURE 1. Verify the customer concern. 2. Remove the roof molding clips, repair the rusted area, and replace the clips with new ones. a. Remove the roof molding according to the procedure on MGSS (ROOF MOLDING REMOVAL). Page 1 of 4 05/03/2022 08:34 AM cciz b. Remove all mounted “Clip A's” from the vehicle. (Two clips for 4-door SD and four clips for 5-door HB). 1 Clip A 2 Clip B 3 Roof Molding 4 Vehicle Front c. Remove the rust (1), clean the surface, and repaint the rusted area. Page 2 of 4 05/03/2022 08:34 AM cciz d. Paint the new “Clip A's” with the same paint of the vehicle, and then install “Clip A's” on the rectangular protrusion (1) on the body side. e. Apply adhesive around each clip (1) (on the yellow rectangular areas) after installing “Clip A's” on the vehicle. f. Reinstall the roof molding according to the procedure on MGSS (ROOF MOLDING INSTALLATION). 3. Verify the reapir. PARTS INFORMATION Part Number Description Qty. Notes - Super glue (Cyanoacrylate glue) 1 Adhesive (products on the market) GJYA-50-629A Clip, Roof Molding 2 (for 4-door SD) or 4 (for 5-door HB) Clip A (both sides) Page 3 of 4 05/03/2022 08:34 AM cciz WARRANTY INFORMATION NOTE: • This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair. • This repair will be covered under Mazda’s New Vehicle Limited Warranty term. • Additional diagnostic time cannot be claimed for this repair. Warranty Type A Symptom Code 53 Damage Code 9Y Part Number Main Cause Quantity Operation Number / Labor Hours: GJYA-50-629A 2 (for 4-door SD) or 4 (for 5-door HB) XXT4AXRX / 0.2 Hrs. NOTE: • MNAO Warranty requires 2 forms attached: D40 (for TSB and photos of paint/rust) and D14 (for the sublet of the paint work). • Preauthorization is required for any total paint repair estimate over $1000. Page 4 of 4 05/03/2022 08:34 AM cciz