RCA-78-22-006-1
Service Bulletin Details
Public Details for: RCA-78-22-006-1
Rivian is initiating a customer satisfaction campaign for some model year 2022 r1t vehicles that may have been built with a low clearance condition between the left front frame harness and the steering column intermediate shaft. If the fram
- 2022 -
Models from 2022
2022 RIVIAN R1T |
RCA-78-22-006-1: Increase Clearance between Frame Harness and Steering Column Rivian is initiating a customer satisfaction campaign for some model year 2022 R1T vehicles that may have been built with a low clearance condition between the left front frame harness and the steering column intermediate shaft. If the frame harness touches the steering column intermediate shaft and this condition persists over time, the vehicle may experience a wear-through condition of the wires in the frame harness. The wear-through condition, which has not been observed to date in any customer vehicle, would only result if the frame harness length is near the limits of the specification and the nearby harness that normally constrains the frame harness is misrouted. The potential wear-through condition may result in a loss of electronic stability control. If loss of electronic stability control occurs, the vehicle will enter a reduced performance safe-state mode and an "Electronic Stability Control (ESC) system malfunction" indicator light will illuminate on the driver display alerting the driver to have service performed on their vehicle. Rivian will install a cable tie to ensure clearance between the frame harness and the steering column intermediate shaft. Rivian is launching this campaign for customer satisfaction and to ensure the quality of Rivian vehicles. Document Type Customer Satisfaction Campaign Bulletin Date April 12, 2022 Affected Region(s) USA Affected Model(s) R1T Model Year(s) 2022 Approximate Build Dates August 2021 - October 2021 Refer to the FSA Dashboard to determine if this document applies to a specific vehicle. Vehicle System 78 - Low Voltage Electrical Minimum Service Location Mobile Required Parts Part Number Quantity Engineering Name Service Name/Notes N/A 2 12 inch cable tie Snap-On TR88303 Attention: The parts listed in this table are only for unique steps that are called out in this bulletin. Some sections of this bulletin might refer to Service Manual procedures which require additional parts. Always review the bulletin and all potentially related Service Manual procedures before ordering parts and beginning work. Procedure 1. Raise and Support Vehicle (refer to service manual procedure 981020017). RCA-78-22-006-1: Increase Clearance between Frame Harness and Steering Column, Page 1 2. Install the cable tie to secure the frame harness to the power steering harness. Tighten the cable tie enough so that the frame harness can not contact the steering column intermediate shaft. 3. Reinstall all components that were removed for access and replace all non-reusable components. Labor Codes Labor Code Description RCA782200600 RCA-78-22-006-1 not applicable RCA782200601 Vehicle inspection only; cable tie already installed RCA782200602 Install cable tie on power steering and frame harnesses to increase clearance to steering column intermediate shaft Contact [email protected] regarding labor codes and document content. RCA-78-22-006-1: Increase Clearance between Frame Harness and Steering Column, Page 2