B15042
Service Bulletin Details
Public Details for: B15042
Symptom there is a fluttering noise from behind the dashboard with the hvac set to floor or defrost mode, the blower set to maximum, and the temperature set to maximum heat. Possible cause under certain hvac settings, the defrost damper
- 2015 -
Models from 2015
2015 ACURA TLX |
Service Bulletin 15-042 February 26 , 2016 02246 Version 3 Fluttering Noise From Behind Dashboard Supersedes 15-042, Dated November 6, 2015; to revise the information highlighted in yellow. AFFECTED VEHICLES Year 2015 2015 2015 Model TLX L4 TLX V6 2WD TLX V6 AWD Trim ALL ALL ALL VIN Range 19UUB1…FA000001 thru 19UUB1…FA022558 19UUB2…FA000001 thru 19UUB2…FA022490 19UUB3…FA000001 thru 19UUB3…FA008262 REVISION SUMMARY In step 3 of the REPAIR PROCEDURE, the illustration showing the self-tapping screw was revised to reflect the proper screw. SYMPTOM There is a fluttering noise from behind the dashboard with the HVAC set to floor or defrost mode, the blower set to maximum, and the temperature set to maximum heat. POSSIBLE CAUSE Under certain HVAC settings, the defrost damper door linkage can flutter. This can be initially triggered by an external impact, such as driving over a pot hole or down a rough road. CORRECTIVE ACTION Install a self-tapping screw into the defrost damper door shaft in the heater case. PARTS INFORMATION Part Name Part Number Quantity Self-Tapping Screw (5 x 16 mm) 90132-SR3-003 1 WARRANTY CLAIM INFORMATION The normal warranty applies. Operation Number 6131L8 Description Install self-tapping screw into the defrost damper door shaft. Flat Rate Time 0.5 hr Template ID 15-042N Failed Part Number 79107-TZ3-A41 Defect Code: 06201 Symptom Code: 04201 Skill Level: Repair Technician CLIENT INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an authorized Acura automobile dealer. © 2015 American Honda Motor Co., Inc. – All Rights Reserved Page 1 of 2 REPAIR PROCEDURE NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. 1. Remove the glove box according to the service information. 2. Remove the HVAC filter cover. 3. Install the self-tapping screw (P/N 90132-SR3-003), into the defrost damper door shaft on the passenger side of the heater case. Start the screw by hand to minimize the chance of dropping and losing it. Tighten the screw until the head is seated against the plastic heater case. NOTE: Do not over torque the screw or you can damage the heater case. 4. Install all parts in the reverse order of removal. Page 2 of 2