TSB-09-55-13

SB-10052497-3814
ATTENTION:
GENERAL MANAGER
PARTS MANAGER
CLAIMS PERSONNEL
SERVICE MANAGER
q
q
q
q
IMPORTANT - All
Service Personnel
Should Read and
Initial in the boxes
provided, right.
SERVICE BULLETIN
APPLICABILITY:	2014MY Forester
NUMBER: 09-55-13
SUBJECT:	Fuel Tank Insulation Pad / Fuel Delivery
Tube Changes
DATE: 06/19/13
INTRODUCTION
This Bulletin informs of changes to both the padding on the fuel tank assembly and the cushions
found on the fuel delivery tubing connecting the main fuel pump assembly to the sub-level unit
(transfer pump).
COUNTERMEASURE IN PRODUCTION
The new parts were incorporated into production starting with VIN E*412069.
PART INFORMATION
PART NAME
NEW PART
NUMBER
NOTES
OLD PART
NUMBER
Tube Delivery
42074SG011
3 Pieces of Tube Cushion
42074SG010
Tube Delivery Sub
42074SG021
3 Pieces of Tube Cushion
42074SG020
SEAT TANK B
(Insulation Pads)
n/a
See Note Below
42016CA010
NOTES
1 Piece of Tube
Cushion
2 Pieces of Tube
Cushion
See Note Below
NOTE: Part interchangeability is from NEW to OLD only
SERVICE PROCEDURE / INFORMATION
SEAT TANK B
(Insulation Pads)
42016CA010
Tube Cushions
OLD
FUEL DELIVERY TUBE
42074SG010/020
42074SG011/021
Additional
Tube Cushions
NEW
Continued...
CAUTION: VEHICLE SERVICING PERFORMED BY UNTRAINED PERSONS COULD
RESULT IN SERIOUS INJURY TO THOSE PERSONS OR TO OTHERS.
Subaru Service Bulletins are intended for use by professional technicians ONLY. They
are written to inform those technicians of conditions that may occur in some vehicles, or
to provide information that could assist in the proper servicing of the vehicle. Properly
trained technicians have the equipment, tools, safety instructions, and know-how
to do the job correctly and safely. If a condition is described, DO NOT assume that this
Service Bulletin applies to your vehicle, or that your vehicle will have that condition.
Bulletin Number: 09-55-13; Date: 06/19/13
SUBARU OF AMERICA, INC. IS
“ISO 14001 COMPLIANT”
The international standard for excellence
in Environmental Management Systems.
Please recycle or dispose of automotive
products in a manner that is friendly to our
environment and in accordance with all
local, state and federal laws and regulations.
Page 1
Follow the procedures in the applicable Service Manual for fuel tank and delivery tubing R&R.
•
When replacing the fuel tank and reusing the original fuel delivery tubes on the new tank, 2
pieces of insulation pad (SEAT TANK B) must be installed onto the new tank to prevent the fuel
delivery tubes from contacting it. Peel the paper backing to expose the adhesive then apply to the
new tank as shown in the illustration below.
NOTE: Before applying the new insulation pads, make sure that area of the tank is clean and dry.
•
When replacing only the fuel delivery tubes, the existing SEAT TANK B (insulation pad)
material can remain in place on the original fuel tank.
•
When replacing both the fuel tank AND the fuel delivery tubes, SEAT TANK B (insulation
pad) does NOT need to be installed onto the new tank due to the additional tube cushions
included with the new tubes.
Installation Locations for Installation of SEAT TANK B (insulation pad) Material
39 +/- 15mm
More than 270mm
SEAT TANK B
(insulation pad)
Tube Cushions
(Old Part Number
Shown)
Bulletin Number: 09-55-13; Date: 06/19/13
Page 2