TI-85-13
Service Bulletin Details
Public Details for: TI-85-13
Porsche: a new type of vent line must be used, if pdk transmission needs replacing, and installed prior to new pdk transmission. Model 2013-2014 911 carrera, 911 carrera s, 911 carrera 4, 911 carrera 4s. *pe
Models from 2014
2014 PORSCHE 911 CARRERA |
Models from 2013
2013 PORSCHE 911 CARRERA |
2013 PORSCHE 911 CARRERA 4 |
SB-10055043-7085 Service Technical Information 85/13 ENU 3734 3 Spare Parts Requirements for PDK Transmission (I-no. 250): Replacing Vent Line (85/13) Vehicle Type: 911 Carrera (991)/911 Carrera S (991) 911 Carrera 4 (991)/911 Carrera 4S (991) Model Year: As of 2013 up to 2014 Equipment: PDK transmission (I-no. 250) Concerns: PDK transmission Information: If the PDK transmission needs to be replaced, make sure to use the new type of vent line: Information If the PDK transmission is to be replaced on a vehicle with a PDK transmission specified under ‘Affected Vehicles’ that was manufactured during the specified time period: on the new PDK transmission – instead of the bleeding system installed on the old PDK transmission Figure 1 – install a modified bleeding system comprising two short breather hoses (90° angled pipes). Figure 1 Affected Vehicles: Vehicle type Part No. of PDK transmission Transmission type Up to transmission number 911 Carrera/ 911 Carrera S without regulated rear-differential lock 9G1.300.011.06 CG105 1012331 2013© Porsche Cars North America, Inc. AfterSales Jan 6, 2014 Page 1 of 4 3 Service 3734 ENU Technical Information 85/13 911 Carrera/ 911 Carrera S with regulated rear-differential lock (PTV Plus, I-no. 221) 9G1.300.031.07 CG105 3022839 911 Carrera 4/ 911 Carrera 4S without regulated rear-differential lock 9G1.300.011.36 CG135 1003920 911 Carrera 4/ 911 Carrera 4S with regulated rear-differential lock (PTV Plus, I-no. 221) 9G1.300.031.37 CG135 3011278 Vehicles manufactured between: 24.01.2013 – 08.08.2013 Action Required: Replace vent line for PDK transmission Parts Info: Work Procedure: 9G1.321.011.03 Breather hose for PDK transmission (2 ea.) Information The vent lines must be installed before installing the new PDK transmission. Fit breather hoses on the new PDK transmission: 1 Fit breather hose for gear wheel set. Information The cable duct remains on the vehicle when the PDK transmission is removed. Jan 6, 2014 Page 2 of 4 AfterSales 2013© Porsche Cars North America, Inc. Service Technical Information 85/13 ENU 3734 3 As an example, the figure shows the required installation position of the breather hose after fitting the cable duct while re-installing the PDK transmission. 1.1 Information The cable duct remains on the vehicle when the PDK transmission is removed. As an example, the figure shows the required installation position of the breather hose after fitting the cable duct while re-installing the PDK transmission. 2 1.2 Position breather hose (Part No. 9G1.321.011.03) Installing breather hose for gear wheel set -1- on the PDK transmission as shown. The breather hose must point to the lower right in direction of travel. 1.3 Slide the breather hose Installing breather Installing breather hose for gear wheel set hose for gear wheel set -1- as far as it will go onto the ventilation connection for the gear wheel set Installing breather hose for gear wheel set -2- ( Installing breather hose for gear wheel set -arrow-). When re-installing the PDK transmission, make sure that the breather hose Installing breather hose for gear wheel set -1- is routed under the cable duct Installing breather hose for gear wheel set -3-. Fit breather hose for clutch chamber. 2013© Porsche Cars North America, Inc. AfterSales Jan 6, 2014 Page 3 of 4 3 Service 3734 ENU Technical Information 85/13 2.1 Position breather hose Installing breather hose for clutch chamber -1- (Part No. 9G1.321.011.03) on the PDK transmission as shown Installing breather hose for clutch chamber. The breather hose must point to the lower left in direction of travel and must be routed under the vacuum line Installing breather hose for clutch chamber -3-. To do this, carefully press the vacuum line to one side. 2.2 Slide the breather hose Installing breather hose for clutch chamber -1- as far as it will go onto the ventilation connection for the clutch chamber Installing breather hose for clutch chamber -2- ( Installing breather hose for clutch chamber -arrow-). Installing breather hose for clutch chamber Working Time: 37461950 – Removing and installing breather hose. Important Notice: Technical Bulletins issued by Porsche Cars North America, Inc. are intended only for use by professional automotive technicians who have attended Porsche service training courses. They are written to inform those technicians of conditions that may occur on some Porsche vehicles, or to provide information that could assist in the proper servicing of a vehicle. Porsche special tools may be necessary in order to perform certain operations identified in these bulletins. Use of tools and procedures other than those Porsche recommends in these bulletins may be detrimental to the safe operation of your vehicle, and may endanger the people working on it. Properly trained Porsche technicians have the equipment, tools, safety instructions, and know-how to do the job properly and safely. If a particular condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your authorized Porsche Dealer for the latest information about whether a particular technical bulletin applies to your vehicle. Part numbers listed in these bulletins are for reference only. Always check with your authorized Porsche dealer to verify the current and correct part numbers. The work procedures updated electronically in the Porsche PIWIS diagnostic and testing device take precedence and, in the event of a discrepancy, the work procedures in the PIWIS Tester are the ones that must be followed. © Porsche Cars North America, Inc. Dealership Distribution Routing Service Manager _______ Shop Foreman _______ Service Technician ________ _______ _______ _______ Asst. Manager _______ Warranty Admin. _______ Service Technician ________ _______ _______ _______ Dr. Ing. h.c. F. Porsche AG is the owner of numerous trademarks, both registered and unregistered, including without limitation the Porsche Crest®, Porsche®, Boxster®, Carrera®, Cayenne®, Cayman®, Panamera®, Speedster®, Spyder®, 918 Spyder®, Tiptronic®, VarioCam®, PCM®, PDK®, 911®, 4S®, FOUR, UNCOMPROMISED.® and the model numbers and the distinctive shapes of the Porsche automobiles such as, the federally registered 911 and Boxster automobiles. The third party trademarks contained herein are the properties of their respective owners. Porsche Cars North America, Inc. believes the specifications to be correct at the time of printing. Specifications, performance standards, standard equipment, options, and other elements shown are subject to change without notice. Some options may be unavailable when a car is built. Some vehicles may be shown with non-U.S. equipment. The information contained herein is for internal use only by authorized Porsche dealers and authorized users and cannot be copied or distributed. Porsche recommends seat belt usage and observance of traffic laws at all times. Printed in the USA Jan 6, 2014 Page 4 of 4 AfterSales 2013© Porsche Cars North America, Inc.