C1007410

SB-10057520-6780
Product Improvement Campaign
No: C1007410
Issued: November 26, 2014
Re: Turbocharger Linkage
Group: 15 Models: FE/FG
Expires: November 26, 2015
SUBJECT:
Product Improvement Campaign C1007410 – Turbocharger Linkage
MODELS:
FEC52, FEC72, FEC92, FGB72
VEHICLES INVOLVED:
Certain 2012 through 2015 model year FEC52, FEC72, FEC92 and FGB72 trucks produced from April 8, 2011
through September 9, 2014.
NOTE:
The information contained in this document is intended for use by trained, professional technicians with the
knowledge, tools, and equipment to properly and safely perform diagnoses and repairs. It informs service
technicians about conditions that may occur in some vehicles, or provides information that could assist in proper
vehicle diagnosis, service, or repair, and does not indicate that a defect is present in every vehicle referenced in
this bulletin. DO NOT assume that a symptom or condition, or a described cause of a symptom or condition,
affects any particular vehicle or that a described repair applies to any particular vehicle. There can be multiple
causes resulting in the same symptoms or conditions, and trained professional service technicians must use their
diagnostic skills to make evaluations on a case-by-case basis.
OWNER NOTIFICATION:
Owners of affected vehicles will be notified by mail.
MODIFICATION:
On all affected vehicles, a cleaner and lubricant will be sprayed onto the turbocharger linkage to prevent rust build
up that could potentially prevent the link from operating normally, resulting in a reduction in engine power. An
initial can of FP100273 Metaflux 70-81 and FP100274 Kano Aerokroil will be automatically invoiced and
shipped to each dealer. Please note that each can of cleaner and lubricant will complete approximately 20
vehicles. Replacement cans of cleaner and/or lubricant can be ordered using the Recall Parts Order Form on
Fusonet.
CAMPAIGN PARTS:
Part #
FP100273
FP100274
Part Name
Metaflux 70-81
Kano Aerokroil
Campaign Parts
Qty.
1
1
Campaign Reimbursement
US$63.18 / 20 trucks = US$3.16
US$24.27 / 20 trucks = US$1.21
CAMPAIGN CLAIM SUBMITTAL:
Claim reimbursement via Fusonet using the Recall Claim Entry screen. Enter all requested information, including
the Campaign Number. The system will apply the labor allowance and parts pricing adjustment shown.
Campaign Reimbursement
Campaign
Number
Models
C1007410
FEC52
FEC72
FEC92
FGB72
C1007420
FEC72
Crew
Cab
Allowances
Labor Time
0.4 hour
Parts Pricing
US$4.37
Labor Time
0.6 hour
Parts Pricing
US$4.37
Labor Description
Part Number
Apply cleaner and lubricant to the turbocharger
linkage.
FP100273
FP100274
Apply cleaner and lubricant to the turbocharger
linkage.
FP100273
FP100274
REPAIR PROCEDURE:
1. Park the vehicle on a flat, level surface, turn off the engine, apply the parking brake and chock the
wheels.
CAUTION! Do not release the parking brake or remove the wheel chocks until all modification
work has been completed.
2. Perform the Campaign using the appropriate section of the attached modification procedure.
2
Turbocharger Linkage Lubrication Procedure
REPAIR PROCEDURE:
1. Park the vehicle on a flat, level surface, turn off the engine, apply the
parking brake and chock the wheels.
CAUTION! Do not release the parking brake or remove the wheel
chocks until all modification work has been completed.
Standard cab
View with the cab tilted from the passenger side.
2. Locate the turbocharger waste gate linkage from the right rear of
the engine.
3. Attach the 40cm nozzle extension to the Kano AeroKroil can. Spray
the upper & lower sections of the linkage until it is coated evenly.
Enlarged view from the right rear
corner of the engine.
4. Remove and clean the 40cm nozzle
extension.
5. Attach the 40cm nozzle
extension to the METAFLEX 70-81
can. Spray the upper & lower
sections of the linkage.
6. Make sure that grease is applied
evenly. Reassemble the removed
parts. Remove and clean the nozzle
extension.
Crew cab
REPAIR PROCEDURE:
1. Park the vehicle on a flat, level surface, turn off the engine, apply the
parking brake and chock the wheels.
CAUTION! Do not release the parking brake or remove the wheel
chocks until all modification work has been completed.
2. Remove the right front tire. Remove the splash guard.
3. Locate the turbocharger linkage and pivot.
4. Attach the 40cm nozzle
extension to the Kano AeroKroil
can. Spray the upper & lower
sections of the linkage.
5. Remove and clean the 40cm
nozzle extension.
6. Attach the 40cm nozzle
extension to the METAFLEX 70-81
can. Spray the upper & lower
sections of the linkage.
7. Make sure that grease is
applied evenly. Reassemble the
removed parts.
8. Remove and clean the 40cm nozzle extension.