TSB-15-01-012

SB-10058137-9331
GROUP
CAMPAIGN
Technical Service Bulletin
DATE
MARCH 2015
NUMBER
15-01-012
MODEL
ELANTRA (UD)
AUTOMATIC TRANSAXLE SHIFT LEVER CLIP INSTALLATION
(SERVICE CAMPAIGN 933)
SUBJECT:
*** Retail Vehicles Only ***
Dealers must perform this Service Campaign whenever an affected vehicle is in the shop for any
maintenance or repair.
When a vehicle arrives at the Service Department, access Hyundai Motor America's "Warranty
Vehicle Information" screen via WEBDCS to identify open Campaigns.
Description:
The end of the cable connecting the transmission range switch to the vehicle’s shift lever pin is
fastened to the pin with a rubber grommet. The connection between the shifter cable and shift lever
pin is critical to ensure proper gear selection (including placing the vehicle in Park). If the cable
becomes disconnected and the vehicle is not in the Park position, the vehicle may roll if the parking
brake is not applied.
This bulletin provides the service procedure to:
1. Verify the connection between the cable and shift lever pin.
2. Install an “E-clip” on the shift lever pin as a supplemental method of securing the cable.
Applicable Vehicles: US manufactured vehicles (VIN begins with 5NPDH~)
2011~13 Elantra (UD) with automatic transaxles
Parts Information:
Part Name
E-clip
NOTE: Each package contains 10 E-clips.
Warranty Information:
Model
Elantra (UD)
Part Number
Qty.
14611-08003-QQH
1
Op. Code
Operation
Op. Time
50CA06R0
E-Clip Installation
0.3
Circulate To: Service Manager, Warranty Manager, Service Advisors, Technicians, Fleet Repair
SUBJECT:
AUTOMATIC TRANSAXLE SHIFT LEVER CAMPAIGN
Repair Procedure:
1. Apply the parking brake.
2
Use a trim tool to remove the left and
right crash pad garnish.
3.
Remove the shift knob.
Without shift boot:
Use a trim tool to slide the trim piece down.
Use a small screwdriver to remove the clip.
Remove the shift knob.
TSB #: 15-01-012
With shift boot:
Pull up on the shift knob until the knob is
disconnected from the shift lever.
Page 2 of 4
SUBJECT:
AUTOMATIC TRANSAXLE SHIFT LEVER CAMPAIGN
4.
Remove two screws that secure the
console upper cover.
5.
Use a plastic trim tool to remove the
console upper cover.
6.
Disconnect the connectors and lay the
console cover on the floor.
Move the shift lever to the N or D
position.
TSB #: 15-01-012
Page 3 of 4
AUTOMATIC TRANSAXLE SHIFT LEVER CAMPAIGN
SUBJECT:
7.
Use pliers to grasp the E-clip as shown.
(Thin pliers are best for this procedure.)
If thin pliers are not available, use small
needle nose pliers to hold the E-clip in
position on the shift lever pin and push
the E-clip into position with a flat
screwdriver.
NOTICE
If necessary, use a flat screwdriver
to fully push the E-clip onto the pin.
8.
Turn the ignition to the ON position and
depress the brake pedal.
Move the shift lever through gears P-R-ND and confirm the E-clip is securely
installed.
9.
Reassemble all parts in the reverse order of disassembly.
Confirm the P-R-N-D lights illuminate in the dash cluster and on the console cover.
TSB #: 15-01-012
Page 4 of 4