14-AT-005
Service Bulletin Details
Public Details for: 14-AT-005
Summary to be provided on a future date.
Models from 2013
2013 HYUNDAI GENESIS |
Models from 2012
2012 HYUNDAI EQUUS |
2012 HYUNDAI GENESIS |
, GROUP HyunDRI l nEWTHlnKlnG. nEW POSSIBILITIES. Technical Service Bulletin AUTOMATIC TRANSMISSION 14-AT-005 1 - - - - -- - -- - - - + - - - - - - - - DATE APRIL 2014 SUBJECT NUMBER MODEL GENESIS SEDAN (BH/DH) GENESIS COUPE (BK) EQUUS (VI) 8-SPEED AUTOMATIC TRANSMISSION FLUID LEVEL This TSB supersedes TSB 12-AT-004-1 to add the 2015 Genesis Sedan (DH) Description: The following vehicles are equipped with an 8-speed automatic transmission. The ATF level can be checked by the following procedure. Applicable Vehicles: 2012- Genesis Sedan 3.8L/4.6L/5.0L, 2012- Equus 5.0L and 2013-Genesis Coupe 2.0L/3.8L with 8-speed automatic transmission PARTS INFORMATION: *NOTE Use only ATF meeting the SPH-IV-RR specification approved by Hyundai. Do not use SP-Ill, SPH-IV or other ATF which may result in degradation of shift quality. WARRANTY INFORMATION: Normal warranty applies ATF LEVEL INSPECTION: 1. Remove the plastic shield under the transmission. 2. If the ATF has been completely drained , go to Step 3. To check the ATF level, go to Step 4. Circulate To: Service Manager, Warranty Manager, Service Advisors, Technicians, Fleet Repair SUBJECT: 3. 8-SPEED AUTOMATIC TRANSMISSION FLUID LEVEL If the ATF has been completely drained: • • • • • Move the shift lever to "N" (engine off). Lift the vehicle on a hoist. Remove the fill plug. Use a fluid pump or suction gun to add SPH-IV-RR ATF through the fill plug. o Engine off. Add approximately 4 quarts of SPH-IV-RR. o Start the engine. Add approximately 4-5 additional quarts of SPH-IV-RR Reinstall the fill plug. Go to Step 4. 4. Attach a GOS and select vehicle, A/T menu, Current Data and "Oil Temperature Sensor". 5. Drive the vehicle until the ATF is at the low end of the range of 122-140°F (50-60°C). 6. Move the shift lever to "N" and leave the engine idling. Raise the vehicle on a hoist. 7. Remove the overflow plug. Remove the fill plug and add SPH-IV-RR ATF until the ATF flows out of the overflow plug in a thin steady oil stream. Reinstall the overflow plug. Torque: 5-8 lb-ft (0.7-11 kgf.m) Reinstall the fill plug. Torque: 25-32 lb-ft (3.5-4.5 kgf.m) ATF TEMPERATURE= 122-140°F (50-60°C) SHIFT LEVER IN "N " AND ENGINE RUNNING Severe service No inspection or replacement Replace ATF at 60,000 miles Severe service is defined as: • Frequent driving on mountain roads • Repeated short distance driving • More than 50% driving in heavy city traffic during hot weather above 90°F (32°C) • Trailer towing or commercial operation such as a taxi TSB #: 14-AT-005 Page 2 of 2