S-SB-0005-14

Technica l Service Bu lletin
~
'2:7
April 14, 2014
S-SB-0005-14
=:;c:::1on
Floor Mat Installation During PDS
Service
Category
General
Section
Pre-Delivery Service
Market
Scion Su pports ~
AS E Certifi cation: W
USA
Applicability
YEAR(S)
MODEL(S)
2015
FR-S . iO . tC . xB
ADDITIONAL INFORMATION
Introduction
2015 model year vehicles are equipped with driver's side floor mat retaining clips to secure the floor
mat in the correct position . In addition , some models may utilize retaining clips for passenger side
floor mats as well . Follow the appropriate installation procedure to attach the driver's side and
passenger's side (if applicable) floor mat to the vehicle carpet using the floor mat retaining clips
during Pre-Delivery Service (PDS) .
CAUTION
• ALWAYS verify the floor mat to ensure it is designed specifically for the model and model
year it is being installed in .
• ONLY use floor mats that can be retained using the retaining clips. All OEM Scion floor mats
are specifically designed to fit correctly and be retained using the retaining clips .
• Make sure the floor mat is properly placed on the vehicle carpet and secured with the retaining
clips. If the driver side floor mat is NOT properly placed and secured, it could slip and interfere
with the movement of the pedals during driving and may cause an accident.
• Verify the operation of the accelerator, brake, and clutch (if equipped) pedals and clearance
to the mat.
• NEVER install more than one floor mat at a time in the driver's seating position.
• If applicable, any secondary set of floor mats (based upon customer preference, such as the
all weather floor mats or other floor mats) MUST be placed in the trunk with all the packaging
material intact. Do NOT install the secondary mat on top of the primary floor mat already
installed in the driver's seating position.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
NIA
Not Applicable to Warranty
-
-
-
-
© 2014 Toyota Motor Sales, USA
Page 1 of 12
S-SB-0005-14
April 14, 2014
Page 2 of 12
Floor Mat Installation During PDS
Installation Procedure: Hook Style
1. Verify that the driver and passenger side (if applicable) floor mats are for the correct model
and model year they are being installed in .
2 . Attach the driver and passenger side (if applicable) floor mats to the vehicle carpet using the
retaining clips. Secure the mat by inserting the retaining clips through the grommet holes.
Figure 1.
I
/
I
I
/
/
·cq
··· 1·..
.
. . .,_
.
:
, I....;,;,, cu,.
2
' ...
'·-
: .. :
;
.
---~ . ~/.
@.,
.
I
-, ·
'
,'
.·
.·
.
..
3
Grommets
© 2014 Toyota Motor Sales, USA
I
·.· ,:· ~ ,._.·
'....:.. ·.· ,~ . :.
Correct Installation
,- .-
.-:.
.
:·-: ,._...
I
Page 3 of 12
April 14, 2014
S-SB-0005-14
Floor Mat Installation During PDS
Installation Procedure: Hook Style (Continued)
3. Verify proper installation .
NOTE
If applicable, DO NOT remove the beige " Caution " tag from the floor mat. This should only be
removed by the customer.
Figure 2.
A
Caution I Prec~uci6n I Attention I .;.:W
A
NOTICE: THIS TAG TO BE REMOVED BY CUSTOMER ONLY.
To. avoid inlgrfete<1ce with pedal Operation:
- E acl'I mat m us\ be secuted v.i lh tslenUOn hooks (dips)
• 1)(1 net install a ~ oo ma! on top or an existin1;1 fl~cr mat
AVISO: SOLAMENTE El CLIENTE DEBE REMOVER ESTA ETIQUETA.
0
P3ra t!\•ltar lr.terferenda con la operacl6n eel pedal:
• Cada ~pete debe su}etarse ccn seguros de retencl6n (broches}
- No lnstal_
e ur. fapete de piso eri~Ema cle un 1apete de plso exlsten e
REMARQUE : CETTE ETIQUETTE NE PEUT ~TRE ENLEV~E QUE PAR LE CLIENT.
Pour tl\~ter des ir1terfef!H1ces avec
le for.cilonnement d€ la padale:
- Chaque:tapis cioiliilro nxA a !'aide ~ es eroctiEits de rete:itioo (agrafe.s)
• N' in slallez pas un tapis pil.1"a~ :...J~}
. ;~1 ~ ~µ 1
cJ...J._ .~')/'µ -~ .
• . IJ.Jl
• . ••.;4-Jl V'•j!. ....A
:li;w ...A
. ..>" t>'J'
. y• 'J -
© 2014 Toyota Motor Sales, USA
:~\i:-..»1 ~,., ~y:. ~
El
;UJ
o;
I
S-58-0005-14
April 14, 2014
Page 4 of 12
Floor Mat Installation During PDS
Installation Procedure: Hook Style with Locking Clip
1. Verify that the driver and passenger side (if applicable) floor mats are for the correct model
and model year they are being installed in .
2. Attach the retention clip to the floor by inserting the retention clip claws into the floor eyelet.
Figure 3.
1
Retention Clip
5
Cross-sectional Diagram
2
Front of Vehicle
A
Retention Clip Claw
3
Retention Clip Eyelet on Vehicle Floor
B
Locking Clip
4
Seat
© 2014 Toyota Motor Sales , USA
Page 5 of 12
April 14, 2014
S-SB-0005-14
Floor Mat Installation During PDS
Installation Procedure: Hook Style with Locking Clip (Continued)
3. To lock the retention clip in place, insert the
locking clip of the retention clip into the
designated hole.
Figure 4.
1
4. Align the floor mat holes with the retention clip
hooks and place the floor mat holes onto the
retention clip hooks.
I
Locking Clip
Figure 5.
1
Retention Clip Eyelet on Floor Mat
2
Retention Cl ip
3
Front
© 201 4 Toyota Motor Sales, USA
April 14, 2014
S-SB-0005-14
Page 6 of 12
Floor Mat Installation During PDS
Installation Procedure: Hook Style with Locking Clip (Continued)
5. Verify proper installation .
NOTE
If applicable, DO NOT remove the beige " Caution" tag from the floor mat. This should only be
removed by the customer.
Figure 6.
A
Caution I Precauci6n I Attention I ~W
A
NOTICE: THIS TAG TO BE REMOVED BY CUSTOMER ONLY.
l o avoid in.l9rfet e<11ce v.i lh pedal oparaliott
• Ea:cti mat .mus\ be Sllcurnd with ts!enlioo flci~ :..JUL..!.}
~~'
...:,~,~~µ V.~··'J!°"~· - :t..\&...\11 ~,.,. ~....)"- ~
.Ww ~Y' i]..) .:;; ._,1.;....11 JJA ~y 'II -
© 2014 Toyota Motor Sales, USA
El
>
lJJ
o;
I
Page 7 of 12
April 14, 2014
5-58-0005-14
Floor Mat Installation During PDS
Installation Procedure : Knob Style with Locking Clip
1. Verify that the driver and passenger side (if applicable) floor mats are for the correct model
and model year they are being installed in .
2. Attach the retention clip to the floor by inserting
the retention clip claws into the floor eyelet.
Figure 7.
---- /
--- I
___®/,
,,}
I
---~
1
Retention Clip
2
Retention Clip Eyelet on Vehicle Floor
3
Seat
4
Front of Vehicle
A
Retention Clip Claws
B
Locking Clip
© 2014 Toyota Motor Sales, USA
S-SB-0005-14
April 14, 2014
Page 8 of 12
Floor Mat Installation During PDS
Installation Procedure: Knob Style with Locking Clip (Continued)
3. To lock the clip in place, insert the locking clip of
the retention clip into the designated hole.
Figures.
...--------------------,
1
4. Align the floor mat holes with the retention clip
knobs and place the floor mat holes onto the
retention clip knobs .
I
Locking Clip
Figure 9.
@. . .
1
Retention Clip Eyelet on Floor Mat
2
Retention Clip
3
Front of Vehicle
© 2014 Toyota Motor Sales, USA
April 14, 2014
S-58-0005-14
Floor Mat Installation During PDS
Installation Procedure: Knob Style with Locking Clip (Continued)
5. Turn the retention clip knobs a quarter of a turn to
lock in place and verify the "triangle" marks on the
retention clip knob and floor mat are aligned.
Figure 10.
1
Twist Knob
2
Knob in Locked Position
3
Align "Triangle" Marks
© 2014 Toyota Motor Sales , USA
Page 9 of 12
Page 10 of 12
April 14, 2014
S-SB-0005-14
Floor Mat Installation During PDS
Installation Procedure: Knob Style with Locking Clip (Continued)
6. Verify proper installation.
Figure 11 .
A
NOTE
If applicable, DO NOT remove the yellow
" Caution" tag from the floor mat. This should
only be removed by the customer.
.
CAUTION
A IA
Use this floor mat for dnver's
S>de only
This ftoor mat was designed
specifically for use in this model
and model year vehicle and
SHOULD NOT be used In any
other vehicle
To preve nt the ftoor mat from
shifting, the floor mat should be
attached securely to the floor
with the retention clips
To properly use the retention
clips . tum the knobs on the clips
to the look posibon as shown in
the followmg 1llustratlon
The floor mat MUST BE
installed directly on the carpeted
floor of the vehicle a1ld property
sacured ¥.. 1th tho reten tt0n chps
The noor ma t should NEVER
be inslalk>d on top of anothor
floor mat.
NEVER place the ftoor mat
in the vehicle upsidc·down ot
backwards.
PRECAUCION
A
• Use este tapete unicamente
para el !ado del conductor.
Este tapete fue diset\ado
especlficamente para usarse en
este modelo y a~o de veh lculo,
y NO DEBE usarso en nings
sujetadores de retenci6n El
tapete NUNCA debe lnstalarse
enc1ma de otro lapele.
NUNCA coloque el tapete en el
vehfculo boca abajo o al revt'.ls
ALWAYS ALIGN MARK
S!EMPRE AUNEE LAS MARCA$
TOUJ OURS ALIGNER LES MAROOES
...... FRONT
-
fRENTE
AV/foHT
~I
0
@j)
ONLOCJ<
OES6LOQUEAR
~ERRO UIUER
~I
;...::w1........... WI• r1
~
~
LOCK
BLOQ\JEAR
VERROOILL£R
Jill
TFMT - ICOOOI
© 2014 Toyota Motor Sales , USA