T-SB-0025-13

@TOYOTA
T-SB-0025-13
Technical Service Bulletin
February 8, 2013
Antenna Installation During PDS
Service
Category
General
Section
Pre-Delivery Service
Market
Toyota Supports ~
ASE Certification ~
USA
Applicability
YEAR(S)
MODEL(S)
2014
4Runner, FJ Cruiser,
ADDITIONAL INFORMATION
Highlander, Sienna,
Tacoma , Tundra
Introduction
The rad io antenna pole on some models is designed with a hex-cut base and requires installation
using a wrench. When performing PDS or installing the antenna pole for any other reason, inspect
the antenna base for a hex-cut to determine if the following procedure is required.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
-
-
-
-
Installation Procedure
The radio anten na pole and wrench are loaded inside the vehicle at the assembly plant to avoid
damage in transit. Install the anten na during PDS according to the instructions below and place
the wrench in the glove box for the customer.
1. Remove the protective shipping plug from the antenna base of the fender.
2. Screw the antenna pole into the antenna base and tighten by hand until fu lly seated.
© 201 3 Toyota Motor Sales, USA
Page 1 of 2
@TOYOTA
February 8, 2013
T-SB-0025-13
Page 2 of 2
Antenna Installation During PDS
Installation Procedure (Continued)
3. Using an 8 mm wrench, fully tighten the antenna
pole by rotating the base 1/8 of a turn (20 to 45
degrees) clockwise.
Figure 1.
Torque : 3.3 N*m (34 kgf*cm, 29 in*lbf)
NOTICE
..
• Do NOT over-tighten .
• Do NOT use pliers to tighten the antenna
pole as damage can occur to the antenna
pole surface.
NOTE
The antenna pole cannot be tightened by hand
to the proper specification.
I I
1
© 2013 Toyota Motor Sales, USA
Hex-cut Type Antenna