L-SB-0088-13
Service Bulletin Details
Public Details for: L-SB-0088-13
Summary to be provided on a future date.
- 2014 -
Models from 2014
2014 LEXUS CT 200H |
2014 LEXUS CT HYBRID |
L-SB-0088-13 December 3, 2013 Technical Service Information Bulletin Short Pin Installation During PDS Service Category General Section Pre-Delivery Service Lexus Supports Market ~ ASE Certification. USA Applicability YEAR(S) MODEL(S) 2014 CT200H ADDITIONAL INFORMATION Introduction To minimize battery discharge during transportation and storage, the Short Pin has been removed at the assembly plant and temporarily stored in the engine compartment Relay Block. Reinstall the Short Pin and confirm all related DTCs are cleared during Pre-Delivery Service (PDS) . Warranty Information OP CODE DESCRIPTION TIME OFP T1 T2 N/A Not Applicable to Warranty - - - - Required Tools & Equipment REQUIRED EQUIPMENT SUPPLIER QTY TS2UNIT Techstream 2.0* TIS Techstream PART NUMBER ADE Techstream Lite 1 TSPKG1 TSLITEDLR01 • Essential SST. NOTE • Only ONE of the Techstream units listed above is required. • Software version 8.30.023 or later is required. • Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE) at 1-800-368-6787. © 2013 Lexus, a division of Toyota Motor Sales, USA Page 1 of 2 L-SB-0088-13 December 3, 2013 Page 2 of 2 Short Pin Installation During PDS Short Pin Installation Procedure Remove the Short Pin from the blank space of the Relay Block in the engine compartment and install the Short Pin as shown in Figure 1. Figure 1. 2 1 Relay Block 3 2 Short Pin Storage Location Install Short Pin Here (Original Location) NOTE • The Short Pin does not function as a fuse, so only install it in the position shown above. • If the vehicle is stored after PDS, disconnect the negative (-) battery terminal to prevent battery discharge. Refer to Service Bulletin No. PG001-06, "Battery Maintenance for In-Stock Vehicles & Pre-Delivery". OTC Clearing Procedure With the Short Pin removed, the Occupant Classification ECU and Center Airbag Sensor Assembly (airbag ECU) may detect the interruption in battery voltage (B+) and store a DTC. Clear DTCs 81650, 81794, and U0208 after installing the Short Pin . 1. Connect Techstream to the DLC3. 2. Cycle the ign ition switch to the "IG-ON" position. 3. Using Techstream, check for stored DTCs. HINT If any DTCs besides 81650, 81794, and U0208 are stored, repair the applicable system according to the Repair Manual. 4. Erase OTCs (B 1650, B 1794, and U0208 ) and Freeze Frame Data. © 2013 Lexus, a division of Toyota Motor Sales, USA