JTB00299NAS1

Page 1 of 2
TECHNICAL BULLETIN
JTB00299NAS1
31 MAY 2013
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools,
and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some
vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-ityourselfers'. If you are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized
Jaguar service facility to determine whether this bulletin applies to a specific vehicle.
SECTION: 303-14A
Engine Detonation Under Moderate Load
AFFECTED VEHICLE RANGE:
XK Range (X150) - 5.0L
Supercharged only
Model Year:
2010 Onwards
VIN:
B32753 Onwards
MARKETS:
NAS
CONDITION SUMMARY:
Situation: At approximately 1,200-1,500 rpm and while under a moderate load, the engine may exhibit an
audible 'detonation'.
Cause: This may be cause by an EMS Calibration error.
Action: In the event of a customer concern of the above, refer to the Service Instruction outlined below.
PARTS:
No Parts Required
TOOLS:
NOTE: This document is an 'Active Bulletin' that will display a functional programming shortcut if
accessed within a diagnostic session using SDD.
IDS with latest IDS-DVD and Calibration File; first available on DVD134.01 v.133
Jaguar Land Rover-approved Midtronics Vehicle Power Supply
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change;
those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair
time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part
number with a quantity of zero.
DESCRIPTION
SRO
Configure existing powertrain control module 86.99.26
TIME (HOURS) CONDITION CODE CAUSAL PART
0.30
42
C2P16956
NOTE: Normal Warranty policies and procedures apply.
SERVICE INSTRUCTION:
http://topix.jaguar.jlrint.com/topix/service/document/415164
6/5/2013
Page 2 of 2
1.
CAUTION: Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform
these steps may cause damage to control modules in the vehicle.
CAUTION: A Jaguar Land Rover-approved Midtronics Vehicle Power Supply must be connected
to the vehicle battery during IDS / SDD diagnosis / module programming.
NOTE: IDS must be loaded with DVD134.01 v.133 or later.
Connect the Jaguar Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.
2. Turn ignition 'ON' (engine not running).
3. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics
(SDD) session.
4. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
5. Select 'Diagnosis' from the Session Type screen.
6. Select the 'Selected Symptoms' tab, and then select the following:

 Powertrain - Engine system - Engine performance - Noises - Under load
7. Select the 'Recommendations' tab.
8. Select 'continue'.
9. From the Recommendations tab, select 'Run' to perform the 'Configure existing module – Powertrain front
control module' option.
10. Follow all on-screen instructions to complete this task.
11. Exit the current session.
12. Disconnect the IDS and the vehicle power supply from the vehicle.
http://topix.jaguar.jlrint.com/topix/service/document/415164
6/5/2013