04-06-04-015A

File in Section:
Service Bulletin
Bulletin No.:
Date:
06 - Engine
04-06-04-015A
December, 2006
TECHNICAL
Subject:
LN2, L43 or L35 Engine SES/MIL Light Illuminated, AIR Pump Ingesting Water and DTC
P0410 Set (Replace AIR Pump and Inlet Hose Assembly)
Models:
1999–2003 Chevrolet Blazer, S10
1999–2001 GMC Jimmy
1999–2003 GMC Sonoma
1999–2001 Oldsmobile Bravada
with Vortec 2.2L I4 or 4.3L V6 Engine (VINs 4, 5, W — RPOs LN2, L43, L35)
This bulletin is being revised to remove a part number and change the two AIR pump part
numbers in the Parts Information. Please discard Corporate Bulletin Number 04-06-04-015
(Section 06 — Engine/Propulsion System).
Condition
Some customers may comment on the SES/MIL light being illuminated. Upon investigation, the technician may find
a DTC P0410 indicating that there is a concern in the secondary air injection system.
Cause
Water may have collected in the AIR pump or the vent solenoid and frozen or corroded the pump.
Correction
Replace the AIR pump and install a new inlet hose and solenoid tube assembly using the following procedure:
1. Raise the vehicle on a hoist.
2. Remove the shield covering the AIR pump.
3. Remove the hose and vacuum lines from the pump and solenoid.
4. Remove the AIR pump inlet hose. Do not re-use the hose.
5. Disconnect the electrical connectors from the pump and solenoid.
6. Remove the pump mounting bolts and pump.
7. Transfer the isolators from the old pump to the new pump.
8. Install the new AIR pump and bolts to the vehicle.
Tighten
Tighten the bolts to 17 Y (12.5 lb ft).
9. Route the new hose assembly up between the engine and fender. The hose should come up near the area
between the battery and the coolant bottle.
10. Connect the new inlet hose to the pump inlet.
11. Connect the old outlet hose to the pump outlet.
12. Connect the electrical connector to the pump.
13. Connect the electrical connector for the solenoid to the connector on the new hose assembly.
14. Connect the hose with the white nipple to the vacuum source hose.
15. Connect the remaining hose to the shut off valve.
16. Install the shield covering the AIR pump.
17. Lower the vehicle.
18. Remove the coolant reservoir nut nearest the battery.
19. Route the new hose assembly between the battery and the coolant reservoir with the solenoid on top.
20. Install the solenoid bracket onto the coolant reservoir stud and reinstall the nut back into the vehicle.
21. Use a wire tie to keep the new hose assembly away from the engine. On four cylinder engines, tie to the AIR
outlet hose. On six cylinder engines, tie to an available hole in the radiator fan shroud.
Parts Information
Part Number
Description
Qty
17803251
Pump Kit, Secondary Air Injection
2001 L35
2000-2003 L43/LN2
1
17803252
Pump Kit, Secondary Air Injection
1999-2000 L35
1
Warranty Information
For vehicles repaired under warranty, use:
Labor
Operation
J6050
Description
Pump, Secondary Air Injection Replace
Labor
Time
Use
Published
Labor
Operation
Time