12-174-14

ATTENTION:
CLAIMS PERSONNEL q
IMPORTANT - All
Service Personnel
Should Read and
Initial in the boxes
provided, right.
SERVICE MANAGER
© 2014 Subaru of America, Inc. All rights reserved.
GENERAL MANAGER q
PARTS MANAGER
q
q
SERVICE BULLETIN
APPLICABILITY:	2012-13MY Impreza 2.0L NA Models
2014MY Forester Models
SUBJECT:
NUMBER: 12-174-14
DATE: 10/30/14
Instrument Panel Side Vents Coming Loose
INTRODUCTION
To address customer concerns of the instrument panel side dash grille vent assembly coming loose,
the retaining claw portion has been redesigned to provide better retention.
COUNTERMEASURE IN PRODUCTION
Vent assemblies with the new retaining claws were incorporated into production per the chart below:
MODEL
STARTING VIN
Impreza 2.0L and
XV Crosstrek
Impreza - E*004587
2014MY Forester
E*034301
XV - E*210621
Continued...
CAUTION: VEHICLE SERVICING PERFORMED BY UNTRAINED PERSONS COULD
RESULT IN SERIOUS INJURY TO THOSE PERSONS OR TO OTHERS.
Subaru Service Bulletins are intended for use by professional technicians ONLY. They
are written to inform those technicians of conditions that may occur in some vehicles,
or to provide information that could assist in the proper servicing of the vehicle. Properly
trained technicians have the equipment, tools, safety instructions, and know-how to
do the job correctly and safely. If a condition is described, DO NOT assume that this
Service Bulletin applies to your vehicle, or that your vehicle will have that condition.
Bulletin Number: 12-174-14; Date: 10/30/14
SUBARU OF AMERICA, INC. IS
ISO 14001 COMPLIANT
ISO 14001 is the international standard for
excellence in Environmental Management
Systems. Please recycle or dispose of
automotive products in a manner that is friendly
to our environment and in accordance with all
local, state and federal laws and regulations.
Page 1
PART INFORMATION
PART NAME:
PART NUMBER
NOTES
Grille Vent AY SD RH
66110FJ020
Grille Vent AY SD LH
66110FJ030
These parts are interchangeable
between Impreza, XV Crosstrek
and Forester models.
SERVICE PROCEDURE / INFORMATION
Should you encounter a complaint of the side grille vent(s) being loose, replace the loose vent with
one which has the new design retaining claws. There has been no change to the current Service
Manual procedure for grille vent replacement.
REMINDERS:
•
When removing the grille vent assembly, always use a plastic trim tool to release the
retaining claws and protect the surrounding instrument panel surfaces.
•
When installing the grill vent assembly, always confirm the new part is inserted fully into the
corresponding air vent duct.
WARRANTY / CLAIM INFORMATION
For vehicles within the Basic New Car Limited Warranty period, this repair may be claimed using the
following information:
LABOR DESCRIPTION
LABOR
OPERATION #
FAIL
CODE
LABOR
TIME
Side Vent Grille One or Both R&R
A726-201
YBD-48
0.2
REMINDER: SOA strongly discourages the printing and/or local storage of service information
as previously released information and electronic publications may be updated at any time. Always
refer to STIS for the latest service information before performing any repairs.
Bulletin Number: 12-174-14; Date: 10/30/14
Page 2