TT46-13-01

Tech Tips
Date: September 20, 2013
TT 46-13-01
Uneven Rear Brake Pad Wear 2009-2012 Routan (Vehicles
Built Before 3/24/2012)
For uneven rear brake pad wear, off-brake noise or an issue other than the piston does not screw-in or readjust out, Do Not replace the rear caliper assembly.
Remove the rear brake pads. Inspect the rear pads for signs of very uneven wear. Check for the following:
•
Both inner vs. outer or left rear vs. right rear are uneven
•
Pads did not slide freely on the adaptor
•
There were signs of brake drag.
When replacing rear brake pads, it is necessary to replace both rear brake caliper adaptors.
(x2) Rear Brake Carrier 7B0-615-425B
Rear Brake Pads
7B0-698-451E
(x1)
Refer to Elsa Web- Repair Manual>Chassis>46 Mechanical Components> Removal/Installation> Rear
Brake Pads.
NOTE: There are two different sets of shims in the pad kit. The shims with the long leg (below)
should be used. If installed in wrong orientation, pads will not fit properly. If the pads have a
protective paper on the rear face of the brake plate, it must be removed before pad installation.
New Clip Part number 7B0698269A
Page 1 of 1
ver1.2
© 2013 Volkswagen Group of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Volkswagen Group of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this
document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these
materials be modified or reposted to other sites, without the prior expressed written permission of the publisher.