T-SB-0154-13

@TOYOTA
T-SB-0154-13
Technical Service Bulletin
October 10, 2013
Front Spoiler Under Cover & Rear Side Spoiler Installation
during PDS
Service
Category
General
Section
Pre-Delivery Service
Market
Toyota Supports ~
ASE Certification -
USA
Applicability
YEAR(S)
MODEL(S)
2014
Prius, Prius PHV
ADDITIONAL INFORMATION
Introduction
The Front Spoiler Under Cover and Rear Side Spoiler are located in the luggage compartment at
the assembly plant to avoid damage in transit. Install the Front Spoiler Under Cover and Rear Side
Spoiler on the vehicle during Pre-Delivery Service (PDS) using the following procedure.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
-
-
-
-
Front Spoiler Under Cover Contents:
• Front Spoiler Under Cover
• 1 plastic retainer clip
• 2 bolts
• 2 plastic screw grommets
• 4 self-tapping screws
Rear Side Spoiler Contents:
• Rear Side Spoiler
(Left and Right)
• 3 plastic retainer clips
• 1 plastic wing nut
• 4 plastic screw grommets
• 6 self-tapping screws
© 2013 Toyota Motor Sales, USA
Page 1 of 5
@TOYOTA
October 10, 2013
T-SB-0154-13
Page 2 of 5
Front Spoiler Under Cover & Rear Side Spoiler Installation during PDS
Front Spoiler Under Cover Installation Procedure
1. Remove the 2 self-tapping screws from the front
wheel well assembly.
Figure 1.
....-------------------.
Remove the 4 bolts from the engine under cover.
NOTE
Retain these screws and bolts as they will be
used later during installation.
Install the 2 plastic screw grommets into the front
bumper as shown in Figure 1.
2. Place both lips of the front spoiler under cover
into the bumper cover. Install the plastic retainer
clip into center hole.
1
Plastic Screw Grommets
2
Self-tapping Screws
3
Bolts
Figure 2.
.....------------------.
1
Lips of Front Spoiler Under Cover
2
Plastic Retainer Clip
© 2013 Toyota Motor Sales, USA
@TOYOTA
T-SB-0154-13
October 10, 2013
Page 3 of 5
Front Spoiler Under Cover & Rear Side Spoiler Installation during PDS
Front Spoiler Under Cover Installation Procedure (Continued)
3. Install the 2 bolts from the kit and the 4 bolts
removed from the engine under cover into the
back of the front spoiler under cover.
Figure 3.
1
I
Bolts
4. Install the 4 self-tapping screws from the kit in the Figure 4.
location marked "A" and the 2 self-tapping screws . . . . . - - - - - - - - - - - - - - - - - - - - .
from the Front Wheel Assembly into the locations
marked "B" into the front of the front wheel spoiler
/ /
under cover.
NOTE
Do NOT over tighten screws.
1
Self-Tapping Screws " A" (from Kit)
2
Self-Tapping Screws " B" (from Front Wheel
Assy)
© 2013 Toyota Motor Sales, USA
@TOYOTA
T-SB-0154-13
October 10, 2013
Front Spoiler Under Cover & Rear Side Spoiler Installation during PDS
Rear Side Spoiler Installation
1. Install 2 plastic screw grommets to the right rear
bumper cover.
Figures.
1
2. Install right rear side spoiler with 3 self-tapping
screws, retainer clip, and plastic wing nut.
I
Plastic Screw Grommets
Figure 6.
1
Self-Tapping Screws
2
Plastic Wing Nut
3
Plastic Retainer Clip
© 2013 Toyota Motor Sales, USA
Page 4 of 5
@TOYOTA
T-SB-0154-13
October 10, 2013
Front Spoiler Under Cover & Rear Side Spoiler Installation during PDS
Rear Side Spoiler Installation (Continued)
3. Install 2 plastic screw grommets to the left rear
bumper cover.
Figure 7.
1
4. Install left rear side spoiler with 3 self-tapping
screws and 2 retainer clips.
I
Plastic Screw Grommets
Figure 8.
1
Self-Tapping Screws
2
Plastic Retainer Clip
© 2013 Toyota Motor Sales, USA
Page 5 of 5