B16-024

Service Bulletin
16-024
April 21, 2016
02412 Version 1
Center Console Lid Will Not Automatically Slide Close with Release
Button
AFFECTED VEHICLES
Year
2016
2016
Model
RLX
RLX Sport Hybrid
Trim
ALL
ALL
VIN Range
ALL
ALL
SYMPTOM
When you press the release button, the center console lid won’t automatically close.
POSSIBLE CAUSE
There is too much friction in the mechanism to overcome the closure spring force.
CORRECTIVE ACTION
Replace the center console lid.
PARTS INFORMATION
Part Name
Part Number
Quantity
Center Console Lid (YR422L (Light Orchid), N-Off White)
83410-TY2-A04ZA
1
Center Console Lid (NH802L (Light Jewel Gray), B-Gray)
83410-TY2-A04ZB
1
Center Console Lid (NH690L (Premium Black), A-Black)
83410-TY2-A04ZC
1
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation
Number
Description
Flat Rate
Time
Defect
Code
Symptom
Code
Replace center console
lid. (YR422L (Light
Orchid), N-Off White)
0421A2
Replace center console
lid. (NH802L (Light
Jewel Gray), B-Gray)
0.3 hr
Replace center console
lid. (NH690L (Premium
Black), A-Black)
Skill Level:
07403
Template ID
Failed Part
Number
16-024N
83410-TY2-A02ZA
16-024P
83410-TY2-A04ZB
16-024Q
83410-TY2-A04ZC
03217
Repair Technician
CLIENT INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and
training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume
this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an
authorized Acura automobile dealer.
© 2016 American Honda Motor Co., Inc. – All Rights Reserved
Page 1 of 4
REPAIR PROCEDURE
1. Pull back on the damper arm to release it from the center console lid.
2. Press the upper lock release lever to release this end of the lid.
3. Press the lock release button to release the lid, then remove it.
Page 2 of 4
4. Install the new center console lid to the center console as shown, then press the lock release button and maneuver
the lid until it clicks into the hole to secure it into place.
5. Press the lower lock release lever until it clicks into place.
NOTE: You may need to move the lid back and forth to get the pin to line up with the hole and click into place
Page 3 of 4
6. Insert the damper rod to the console lid until it clicks into place.
7. Make sure the lid opens and slides normally.
END
Page 4 of 4