A16-037

Service Bulletin
16-037
May 25, 2016
04078 Version 1
O2 Sensor Bracket Rattle
AFFECTED VEHICLES
Year
Model
2016
HR-V
Trim
2WD only
VIN Range
ALL
SYMPTOM
At low speeds and light acceleration there is a rattle from the O2 sensor bracket.
POSSIBLE CAUSES
The O2 sensor bracket may not have the correct bend, allowing the harness to rattle.
CORRECTIVE ACTION
Replace the O2 sensor bracket.
PARTS INFORMATION
Part Name
Part Number
Quantity
Oxygen Sensor Bracket
36537-51M-A00
1
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation
Number
Description
Flat Rate
Time
Defect
Code
Symptom
Code
Template ID
Failed Part
Number
1191B1
Replace the O2 sensor
bracket.
0.3 hr
07403
04201
16-037A
36537-51M-A00
Skill Level:
Repair Technician
Page 1 of 2
CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools,
equipment, and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you
should not assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information
applies, contact an authorized Honda automobile dealer.
© 2016 American Honda Motor Co., Inc. – All Rights Reserved
REPAIR PROCEDURE
1. Remove the O2 sensor bracket and release the harness.
2. Inspect the bracket.
•
•
If the bracket has a slight bend as shown, the bracket is good. Continue with normal troubleshooting.
If the bracket has no bend, replace the bracket.
3. Install the new bracket and torque the nut to 9.4 N·m (6.9 lb-ft), Then install the harness to the bracket.
END
Page 2 of 2