A01165720410934
Service Bulletin Details
Public Details for: A01165720410934
This technical bulletin explains how to proceed when there is an issue with the rubber oil drain plug.
Models from 2017
2017 AUDI Q7 |
Models from 2016
2016 AUDI A6 |
2016 AUDI A7 |
2016 AUDI A8 |
Models from 2015
2015 AUDI A8 |
Technical Service Bulletin 01 Oil pressure warning in DIS (DTC P164D00) 01 16 57 2041093/4 April 11, 2016. Supersedes Technical Service Bulletin Group 01 number 16-54 dated March 7, 2016 for reasons listed below. Model(s) Year VIN Range Vehicle-Specific Equipment A6, A7 2016 000001 - 108668 3.0 TFSI (EVO) A8 2015 All 3.0 TFSI (EVO) A8 2016 000001 - 012861 3.0 TFSI (EVO) Q7 2017 000001 - 002942 3.0 TFSI (EVO) Condition REVISION HISTORY Revision Date Purpose 4 - Revised header data (Added Q7) 3 3/7/2016 Completely revised 2 7/10/2015 Revised Warranty (Corrected TU for 2114 1908) Revised Service (Updated image) • The following DTC is stored in the engine control module, J623 (address word 01): • DTC P164D00 (Oil pressure switch for reduced oil pressure malfunction) • One or both of the following warnings may be displayed in the DIS: • The red oil pressure warning light. • An oil warning: “shut vehicle off”. Technical Background Rubber oil drain plug within the oil filter housing is out of position or has insufficient pre-tension. Production Solution Improved rubber plug and spring. © 2016 Audi of America, Inc. Page 1 of 3 All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin Service Before proceeding, confirm the condition: • If the red oil pressure warning light is not on and DTC cannot be reproduced: • Replace the rubber plug and spring (Figure 1). • If the red oil pressure warning light is on and DTC can be reproduced: • Perform oil pressure test as instructed by GFF (with engine oil temperature at 80°C): If oil pressure is above 0.7 bar after test: Replace the rubber plug and spring (Figure 1), then re-check oil pressure (with engine oil temperature at 80°C). The oil pressure must be above 1.4 bar at idle. If it is not, contact TAC. If oil pressure is below 0.7 bar after test: Contact TAC. Figure 1. Rubber plug with spring. Warranty Claim Type: Use applicable claim type. If vehicle is outside any warranty, this Technical Service Bulletin is informational only. Service Number: 1733 Damage Code: 0016 Labor Operations: Oil pressure check (if required) 1703 0108 120 TU (For A6,A7,A8) 80 TU (For Q7) Diagnostic Time: Replace plug with spring (if required) 1733 1999 20 TU GFF – Checking and clearing fault codes 0150 0000 20 TU Road test after service procedure 0121 0004 10 TU Technical diagnosis at dealer’s discretion (Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details) Claim Comment: As per TSB #2041093/4 All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual. Claims are subject to review or audit by Audi Warranty. © 2016 Audi of America, Inc. Page 2 of 3 All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin Required Parts and Tools Part Number Part Description Quantity 06E115489 Spring 1 06E115475 Rubber plug 1 Additional Information All parts and service references provided in this TSB (2041093) are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information. © 2016 Audi of America, Inc. Page 3 of 3 All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher.