L-SB-0078-15

Service Bulletin Details

Public Details for: L-SB-0078-15

"lsb: to minimize battery discharge during transportation and storage, the dcc fuses (30a) have been removed at the assembly plant and temporarily stored in the blank spaces of the fuse block cover in the engine compartment. During pre-del


- 2016 -

Models from 2016
2016 LEXUS LS460
2016 LEXUS LS600H 
L-SB-0078-15
October 13, 2015
DCC Fuse Installation during PDS
Service
Category
General
Section
Pre-Delivery Service
Market USA
Applicability
YEAR(S)
MODEL(S)
2016
LS460, LS600H
ADDITIONAL INFORMATION
Introduction
To minimize battery discharge during transportation and storage, the DCC fuses (30A) have
been removed at the assembly plant and temporarily stored in the blank spaces of the fuse
block cover in the engine compartment.
During Pre-Delivery Service (PDS), reinstall the DCC fuses into their original locations.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
Installation Procedure
1. Push the core of the engine compartment side
cover clips and remove them. Then remove the
engine compartment side cover.
© 2015 Lexus, a division of Toyota Motor Sales, USA
Page 1 of 3
L-SB-0078-15
October 13, 2015
Page 2 of 3
DCC Fuse Installation during PDS
Installation Procedure (Continued)
2. Make sure that the wheels are pointing straight ahead and the steering wheel is centered
before installing the DCC fuses.
NOTE
The procedure above is necessary to perform the VGRS initialization correctly.
3. With the ignition switch OFF, install the DCC fuses into their original locations in the engine
compartment fuse block.
NOTE
• While the vehicle is stored at the dealership, disconnect the negative (–) battery terminal
to prevent battery discharge. Refer to Service Bulletin No. PG001-06, “Battery
Maintenance for In-Stock Vehicles & Pre-Delivery,” for battery maintenance information.
• If the DCC fuses are installed with the ignition switch in the “IG-ON” position,
Diagnostic Trouble Codes (DTCs) will be detected. In that case, clear the DTCs.
• If the ignition switch is cycled to the “IG-ON” position without the DCC fuses
installed, turn the ignition switch to the “IG-OFF” position and wait for more than 10
seconds before installing the fuses.
© 2015 Lexus, a division of Toyota Motor Sales, USA
Page 2 of 3
L-SB-0078-15
October 13, 2015
Page 3 of 3
DCC Fuse Installation during PDS
Installation Procedure (Continued)
4. Replace the engine compartment side cover.
Installation is in the reverse order of removal.
When inserting the clips, refer to Figure 3.
© 2015 Lexus, a division of Toyota Motor Sales, USA
Page 3 of 3

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.