T-SB-0071-15

T-SB-0071-15
September 10, 2015
Antenna Installation During PDS
Service
Category
General
Section
Pre-Delivery Service
Market USA
Applicability
YEAR(S)
MODEL(S)
2016
Sienna, Tundra
ADDITIONAL INFORMATION
Introduction
The radio antenna pole on some models is designed with a hex-cut base and requires installation
using an 8 mm wrench. When performing PDS or installing the antenna pole for any other reason,
inspect the antenna base for a hex-cut to determine if the following procedure is required.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
Installation Procedure
The radio antenna pole and wrench are loaded inside the vehicle at the assembly plant to avoid
damage in transit. Install the antenna during PDS according to the instructions below and place the
wrench in the glove box for the customer.
1. Remove the protective shipping plug from the antenna base of the Fender.
2. Screw the antenna pole into the antenna base and tighten by hand until fully seated.
© 2015 Toyota Motor Sales, USA
Page 1 of 2
T-SB-0071-15
September 10, 2015
Antenna Installation During PDS
Installation Procedure (Continued)
3. Using an 8 mm wrench, fully tighten the
antenna pole by rotating the base 1/8 of
a turn (20 to 45 degrees) clockwise.
Figure 1.
Torque: 3.3 N*m (34 kgf*cm, 29 in*lbf)
NOTICE
 Do NOT overtighten.
 Do NOT use pliers to tighten the
antenna pole as damage can
occur to the antenna pole surface.
NOTE
The antenna pole cannot be
tightened by hand to the proper
specification.
1
© 2015 Toyota Motor Sales, USA
Hex-cut Type Antenna
Page 2 of 2