L-SB-0056-15

L-SB-0056-15
September 21, 2015
Initial Calibration of Compass during PDS
Service
Category
Section
Market USA
Pre-Delivery Service
Applicability
YEAR(S)
MODEL(S)
2016
CT200H
ADDITIONAL INFORMATION
Introduction
Some 2016 model year CT 200h vehicles are equipped with a compass in the rear view mirror.
In order for the compass to correctly indicate the direction that the vehicle is heading, it must be
calibrated prior to vehicle delivery. Use the appropriate procedure (depending on mirror type) to
perform initial calibration during Pre-Delivery Service (PDS).
Figure 1. Type A and B Mirrors
A
Type A
1
“AUTO” Switch
B
Type B
2
Compass Display
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
-
-
-
-
© 2015 Lexus, a division of Toyota Motor Sales, USA
Page 1 of 3
L-SB-0056-15
September 21, 2015
Page 2 of 3
Initial Calibration of Compass during PDS
Calibration Procedure
NOTE
The Calibration Procedure is the same for both Type A and Type B mirrors. This procedure uses
images from a Type A mirror.
1. Cycle the ignition switch to the "IG-ON"
position and hold the "AUTO" switch until the
zone number appears on the display.
Figure 2.
HINT
Pushing the "AUTO" switch turns the
compass display ON or OFF.
2. Push the "AUTO" switch to select the number of the zone where the vehicle is located.
Figure 3.
© 2015 Lexus, a division of Toyota Motor Sales, USA
L-SB-0056-15
September 21, 2015
Initial Calibration of Compass during PDS
Calibration Procedure (Continued)
3. Start the engine and push the “AUTO” switch
until “C” appears on the display.
4. Drive the vehicle slowly at 5 mph (8 km/h), or
less, in a circle until the direction is displayed.
If there is NOT enough space to drive in a
circle, drive around the block until the
direction is displayed.
Figure 4.
Figure 5.
Once the direction is displayed, the
calibration is complete.
NOTE
 Do NOT perform calibration of the
compass in a place where the Earth’s
magnetic field is subject to
interference by artificial magnetic
fields (underground parking, under a
steel tower, between buildings, roof
parking, near a railroad crossing, near
a large vehicle, etc.)
 During calibration, do NOT operate
electric systems (moon roof, power
windows, etc.) as they may interfere
with the calibration.
© 2015 Lexus, a division of Toyota Motor Sales, USA
Page 3 of 3