JTB00472NAS1

Page 1 of 3
TECHNICAL BULLETIN
JTB00472NAS1
18 FEB 2016
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and
equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you
are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar service facility to
determine whether this bulletin applies to a specific vehicle.
SECTION: 418-00
Engine Intermittently Will Not Start
AFFECTED VEHICLE RANGE:
F-TYPE (X152)
Model Year:
2014-2016
VIN:
K05320-K25432
Assembly Plant: Castle Bromwich
MARKETS:
NAS
CONDITION SUMMARY:
Situation: The engine may intermittently fail to start.
Cause: This may be caused by the Battery Junction Box (BJB) connection not being tightened to correct torque value.
Action: Should a customer express this concern, follow the Service Instruction below.
PARTS:
No Parts Required
TOOLS:
Refer to Workshop Manual / Service Instruction for any required special tools.
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change; those
quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part
number with a quantity of zero.
DESCRIPTION
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
Battery Junction Box (BJB) Connection - Torque
Check
86.94.94
0.2
33
T2R5726
NOTE: Normal Warranty procedures apply.
COMPONENT LOCATION
1.
NOTE: Coupe shown; Convertible similar.
Battery Junction Box (BJB) location.
http://topix.jaguar.jlrext.com/topix/service/document/625627
3/1/2016
Page 2 of 3
SERVICE INSTRUCTION:
1. Disconnect the battery cables (see TOPIx Workshop Manual, section 414-01: Battery, Mounting and Cables).
2. Open the Battery Junction Box (BJB) cover.
3. Tighten the distribution plate retaining nut.
• Torque: 12 Nm.
http://topix.jaguar.jlrext.com/topix/service/document/625627
3/1/2016
Page 3 of 3
4. Close the BJB cover.
5. Connect the battery cables (see TOPIx Workshop Manual, section 414-01: Battery, Mounting and Cables).
http://topix.jaguar.jlrext.com/topix/service/document/625627
3/1/2016