JTB00460NAS1

Page 1 of 3
TECHNICAL BULLETIN
JTB00460NAS1
29 JAN 2016
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge,
tools, and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on
some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by
'do-it-yourselfers'. If you are not a Retailer, do not assume that a condition described affects your vehicle. Contact an
authorized Jaguar service facility to determine whether this bulletin applies to a specific vehicle.
SECTION: 419-00
Both Keys Locked In Vehicle
AFFECTED VEHICLE RANGE:
F-TYPE (X152)
Model Year:
2016 Onwards
VIN:
K17984 Onwards
Assembly Plant: Castle Bromwich
XF (X260)
Model Year:
2016
VIN:
Y00124-Y10370
Assembly Plant: Castle Bromwich
XJ Range (X351)
Model Year:
2016 Onwards
VIN:
V82271 Onwards
Assembly Plant: Castle Bromwich
MARKETS:
NAS
CONDITION SUMMARY:
Situation: The vehicle may lock with both keys in the vehicle when operating the exterior handle.
Cause: This may be caused by a software issue with the Remote Function Actuator (RFA).
Action: Should a customer express this concern, refer to the Service Instruction outlined below.
PARTS:
No Parts Required
TOOLS:
NOTE: this Active Bulletin will display a functional programming shortcut if accessed within a
diagnostic session using the Jaguar Land Rover-approved diagnostic tool with latest DVD and
Calibration File.
Jaguar Land Rover-approved diagnostic tool with latest DVD and Calibration File
Jaguar Land Rover-approved Midtronics battery power supply
WARRANTY:
NOTE: the Remote Function Actuator (RFA) may also be referred to as the Keyless Vehicle
Module (KVM).
http://topix.jaguar.jlrext.com/topix/service/document/616288
2/1/2016
Page 2 of 3
NOTE: Repair procedures are under constant review, and therefore times are subject to
change; those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the
latest repair time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal
part number with a quantity of zero.
DESCRIPTION
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
Configure Remote Function Actuator
86.99.64
0.2
42
C2D44410
NOTE: Normal Warranty procedures apply.
SERVICE INSTRUCTION:
CAUTION: a Jaguar Land Rover-approved Midtronics battery power supply must be connected to
the vehicle battery during diagnosis / module programming.
CAUTION: ensure all ignition ON/OFF requests are carried out; failure to perform these steps may
cause damage to control modules in the vehicle.
NOTE: the Jaguar Land Rover-approved diagnostic tool must be loaded with DVD144.00 v.222 or
later.
1Connect the Jaguar Land Rover-approved Midtronics battery power supply to the vehicle battery.
NOTE: the Remote Function Actuator (RFA) may also be referred to as the Keyless Vehicle Module
(KVM).
2Turn ignition ON (engine not running).
3Connect the Jaguar Land Rover-approved diagnostic tool to the vehicle and begin a new session.
4Follow the on-screen prompts, allowing the diagnostic tool to read the VIN and identify the vehicle and
initiating the data collect sequence.
5Select Diagnosis from the Session Type screen.
6Select the Selected Symptoms tab and then select:
• Body > Security and Locking > Handles, locks and latches
7Select continue.
8Select the Recommendations tab and then select Run to perform the Configure existing module Keyless vehicle module option.
9Follow all on-screen instructions to complete this task, ensuring all diagnostic trouble codes (DTC) are
cleared.
http://topix.jaguar.jlrext.com/topix/service/document/616288
2/1/2016
Page 3 of 3
10Exit the current session.
11Disconnect the diagnostic tool and battery power supply from the vehicle.
http://topix.jaguar.jlrext.com/topix/service/document/616288
2/1/2016