SSM72557

TOPIx - SSM72557 - New Keyless Vehicle Module (KVM) cannot communicate with S...
Reference
SSM72557
Models
F-TYPE / X152
Page 1 of 2
XE / X760
XF / X260
XJ / X351
Title
New Keyless Vehicle Module (KVM) cannot communicate with SDD when programming
as new.
Category
Diagnostic Software Hardware
Last modified
15-Dec-2015 00:00:00
Symptom
000101 Diagnostic Concerns
Content
Issue:
X152 – F-Type: From 16MY onwards
X351 – XJ: From 15MY onwards
X260 – XF: From 16MY onwards
X760 – XE: From 16MY onwards
When fitting a new Remote Function Actuator (RFA) (referred to as the Keyless Vehicle
Module - KVM on SDD) with a module part number of:
FK72-19H440 - AE
FK72-19H440 - BE
FK72-19H440 - AF
FK72-19H440 - BF
SDD cannot communicate with the RFA. This will be displayed as a red X for the RFA in
the SDD vehicle specification screen.
Cause:
The new RFA module supplied is manufactured with pre-flashed software for ‘DUAL
CAN’ vehicles. These vehicles are ‘MULTICAN’ and not ‘DUAL CAN’ and will not
communicate with SDD for programming or update without completing the action
instructions detailed below.
Action:
Complete the following steps when replacing an RFA on the vehicles above:1. Use TOPIx to identify the 5 Amp fuse that supplies the power to pin 20 of the RFA.
2. Set the vehicle ignition to ‘ON’. Smart Key not found message will be displayed on
the message centre.
3. Place the Smart Key against the Immobilizer Antenna Unit (IAU).
http://topix.jaguar.jlrext.com/topix/service/archive/605374/index
1/6/2016
TOPIx - SSM72557 - New Keyless Vehicle Module (KVM) cannot communicate with S...
Page 2 of 2
4. Release the Electronic Parking Brake (EPB).
5. Locate the fuse box in the vehicle.
6. Remove and refit the 5 Amp fuse for the RFA.
7. Select Configure new modules - Keyless vehicle module and follow the on screen
instructions in SDD.
http://topix.jaguar.jlrext.com/topix/service/archive/605374/index
1/6/2016