TT011602_2044553

Tech Tips
Date: June 10, 2016
TT 01-16-02
2013-2016 Jetta Hybrid with DTC U1106
The U 1106 fault may set after performing an ECM test plan or when performing basic settings to any
powertrain component. EVAP test plan, or DSG basic settings, for example.
Perform the following to clear this fault.
1. Select Adaptation in OBD for the ECM.
2. Find the adaptation for "Hybrid Drive Customer Service."
3. Click on the empty box in the entry column.
4. Change the value to "not active."
Please note that it takes more than one attempt for the value to save. Be sure to perform a key cycle
between each attempt. If an error message appears, cycle the key and try again. Once the adaptation is
successfully saved, the U1106 fault should clear.
Page 1 of 1
ver1.2
© 2016 Volkswagen Group of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual
property rights of Volkswagen Group of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this
document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these
materials be modified or reposted to other sites, without the prior expressed written permission of the publisher.