A15-054 - 7-28-1

(g)HONDA
Service Bulletin
July 28, 2015
15-054
02196 Version 2
Noncompliance Recall: HR-V Emission (Trim and Year), Tire,
and A/C Labels
Supersedes 15-054, dated July 24, 2015; see REVISION SUMMARY
AFFECTED VEHICLES
Year
Model
2016
HR-V
Trim
ALL
VIN Range
Check the iN VIN status for eligibility
REVISION SUMMARY
The CUSTOMER NOTIFICATION section was added.
BACKGROUND
On a small number of HR-Vs, the vehicle's tire certification label on the driver's doorjamb and the A/C and emission
certification labels under the hood may be missing or have incorrect information listed. This would cause the vehicle to
be noncom pliant with Title 49 of the Code of Federal Regulations, section 571.110, "Tire selection and Rims ... " and
various emissions regulations.
For reporting purposes, there are three noncompliance recalls for checking labels:
15-052, Noncompliance Recall: HR-V Emission, Tire, and AIC Labels - Check that all three labels are present, and also
check the vehicle trim on the emission label.
15-053, Noncompliance Recall: HR-V Emission Label - Check that the emission label is present and check the model
year on the emission label.
15-054, Noncompliance Recall: HR-V Emission (Trim and Year), Tire, and AIC Labels - Check that all three labels are
present and also check the vehicle trim and model year on the emission label.
Do the applicable campaign as indicated in the iN VIN status inquiry.
CUSTOMER NOTIFICATION
Owners of affected vehicles will be sent a notification of this campaign.
Do an iN VIN status inquiry to make sure the vehicle is shown as eligible.
Some vehicles affected by this campaign may be in your used vehicle inventory. These vehicles must be repaired
before they are sold.
Should your dealership sell an unrepaired vehicle that subsequently causes injury or damage because of the recalled
item, the dealership will be solely responsible to the damaged party, and will be required to defend and indemnify
American Honda for any resulting claims. To see if a vehicle in inventory is affected by this recall, do a VIN status
inquiry before selling it.
CORRECTIVE ACTION
Inspect the emission, A/C, and tire label and, if necessary, replace any incorrect labels or apply any missing labels.
CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools,
equipment, and training to correctly and safely maintain your vehicle. These procedures should not be attempted by "do-it-yourselfers," and you
should not assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information
applies, contact an authorized Honda automobile dealer.
© 2015 American Honda Motor Co., Inc. - All Rights Reserved
Page 1 of 5
PARTS INFORMATION
Part Name
Part Number
Quantity
Tire Label
42762-T7W-A00
1
Emission Label:
1
2WD (VIN begins with 3CZRU5)
AWD (VIN begins with 3CZRU6)
A/C Label
17277-51 M-A00
17277-51 M-A 10
1
80050-T7W-A01
NOTE:
•
•
There are a small number of vehicles that will need an emission label. Order emissions labels only after finding a
vehicle that needs one because the emission label is a controlled part, which requires you to have the VIN when
ordering a new one.
There are a small number of vehicles that will need an A/C or tire label. Both labels are available through the normal
parts ordering system.
WARRANTY CLAIM INFORMATION
Operation
Number
Description
Flat
Rate
Time
Defect
Code
Symptom
Code
Failed Part Number
4215B2
Inspect all three labels.
0.3 hr
5ZW00
JT400
42762-T7W-A00
A
Add to apply emission label.
0.1 hr
5ZW00
JT400
42762-T7W-A00
B
Add to apply A/C label.
0.1 hr
5ZW00
JT400
42762-T7W-A00
C
Add to apply tire label.
0.1 hr
5ZW00
JT400
42762-T7W-A00
Skill Level:
Repair Technician
Page 2 of 5
INSPECTION AND REPAIR PROCEDURE
Emission Label Inspection and Replacement
NOTE: The emission label is a controlled part. Make sure you have the VIN available when you are ordering a new one.
1.
Open the hood and make sure the emission label is present at the location shown.
•
•
If the label is present, go to step 2.
If the label is missing, apply a new one:
NOTE: There are 2 emission labels available. Make sure you order the correct one for the vehicle.
Using alcohol and a clean shop towel, clean the hood area where the emission label is placed. Allow the
area to dry.
Peel off the backing from the emission label, and apply it to the hood. Press the label firmly to make sure it
sticks, then go to A/C Label Inspection and Replacement.
(ff)
\.t!J
~
51H-Al0
ONDA MOTOR CO., LTD .
INFORMATION
VEHICLE EMISSION CONTROL INFORMATION
CONFORMS TO REGULATIONS: 2016MY
U.S . EPA: T285 LDV
CALIFORNIA: ULEV JI PC
0B0: CA ll
OBO: CA ll
FUEL: GASOLINE
FUEL: 6ASO\.INE
WU-TWC TWC AFS H02S EGR SFI
GROUP: GHllXVOl.8JA3 EVAP: GHNXR0!06VFB
l.8L
ar REPlt:ED AtCOROl!t "O'IAl!lEIAitE NIMl!A Ii COO( I. ,ur
ll TE.IRS i IOIEl£1 C ES FIRST. IMEIE!fl[I !'/[II 5 1ms.
~-m IOIIIK Cll l[PIJCIIIG m COOL/,NI, ILIIJ.11 m 1.. d, AEC~NOO[OIENU!IE LO!G-urc Alll-mm/rooLU,
~
! FlClORl IIS!lllED LOl,,-l l'E COOLIJII HUil
T!PE 2. rm OOLINI ll PU-HIIEO ilTII IOI OIS!lll[D mcR. 11 oors NOT .!OUIRC i'I IOOITIOIIAL m1.-;,
• ElEll DILUTE THE (OOIJ.IT, (II m LIFE or TII[ Eltm ""' I[ S[ll(IIIL! Slll!l1E [I,
•Cl!!CI OAAC41 !NE COOlAIT U Ill i[S[A I[ rm, 11:11 THE WllATOl.
•F(II fUA!ll[I l«F
110! O! THE COOU!6 ITIJIH, mo Tl[iN [I'S IW ow.u.
LOADED II~ TESTir«i Of THIS mICLE MUST EE CONDUCTED ON AFOUR-WHEEL DRIVE SP£
S!NCHRIJNIZED DIN~EIER. OlltERl!ISE, AOOfi-LOADED TEST PROCEDURE MUST BE PERFORMfO.
2.
Inspect the emission label to make sure the correct vehicle trim is listed. HR-Vs with 2WD (VIN begins with
3CZRU5) should have X·A listed and HR-Vs with AWD (VIN begins with 3CZRU6) should have X·B.
•
•
If the correct vehicle trim is listed, go to step 3.
If the wrong vehicle trim is listed, replace the label.
NOTE: There are 2 emissions labels available. Make sure you order the correct one for the vehicle.
Remove the original label and use 3M adhesive remover to clean any remaining adhesive residue.
Using alcohol and a clean shop towel, clean the hood area where the emissions label is placed. Allow the
surface to dry.
Peel off the backing from the emissions label, and apply it to the hood. Press the label firmly to make sure it
sticks, then go to A/C Label Inspection and Replacement.
~ - '""~ EH I CLE EMISSION CONTROL IN FORMATION
~
CONFORMS TO REGULATIONS: 2016HY
51 -AIO l u.s. EPA : T2B5 LOV
OBD: CA II
FUEL: GASOLINE
4lill, _,. CALIFORNIA: ULEV II PC
OBD: CA II
FUEL: GASOLINE
,uNDA MOTOR CO. , LTD. I
WU-TW C. TWC. AFS H02S EGR SFI
INFORMATION I GROUP: GHNXV01.8JA3 EVAP: GHNXR0106YFB l.Bl
I> THC
fACIORI INSIAllCD LDNG-llFC COOUNI MUSI 8[ REPLACED ACCOROll!G 10 IIAlmllANCE Nl!OER SUB COOE S, QI Al
10 !URS ICHEIU COHES FIRST. THEREAFTER EVERY S !EARS.
l>VllEX AOOI~G OR mum, rnE COOLA!!T, ALWAYS USE HOidt RECO um mum LONG- LIFE A!ITl-mmJcoo I
rm TIIIS COOLAIIT IS m-MllEO WITH m DISTILl{O WATER. IT DOES IIOl REQUIRE ANY ADO!IIOMl NIIIJl6.
I> 1m1 DILUH THE CODUNT, OR lffE LI FE OF m EN61N£ NAT BE S!RIOUILY SHORT!NEO.
I> C EC! OR ADD THE COOWIT AT HE R{S[RV[ TANK , NOT THE RADIATOR.
t>fOR f'IIRrnER INFORIIAflOi ON JH COOLING SYSJEH, AE.ID THE O~NER'S MNUAl OR CHECK rnH !Olli H1!1111 DfAl.8.
z.
LOADED l/M TESTING OF THIS VEHICLE HUST BE CONDUCTED ON AFOUR-WHEEL DRIVE SPEED
SYNCHRONIZED OYNAflOMETER. OTHERWISE, ANON-LOADED TEST PROCEDURE MUST BE PERFOR!IEO.
"-
Page 3 of 5
Inspect the emission label to make sure 2016 is the model year listed as shown.
3.
•
•
If the correct model year is listed, go to A/C Label Inspection and Replacement.
If the wrong model year is listed, replace the label.
NOTE: There are 2 emissions labels available. Make sure you order the correct one for the vehicle.
Remove the original label and use 3M adhesive remover to clean any remaining adhesive residue.
Using alcohol and a clean shop towel, clean the hood area where the emissions label is placed. Allow the
surface to dry.
Peel off the backing from the emissions label, and apply it to the hood. Press the label firmly to make sure it
sticks, then go to A/C Label Inspection and Replacement.
(g)
~
n
VEHICLE EHISSIOH CONTR~,"'!'NfDRilr,SJN
Ji
CONFORMS TO REGULArn IS : 2016MY
U.S. EPA: T2B5 LDV
OBD: CA~
F\JEl: ,i~c· _INE
SlM- AlO
CALIFORNIA: ULEV II PC
0B0: CA 11 ._.._
E
HONDA MOTOR CO., LTD.
WU-TWC TWC AFS H02S EGR SFl
INFORMATI ON GROUP: GHNXVOl.8JA3 EVAP: GHNXR0106VFB l.8L
«11 '
FACTORY l~IIILL!D LO G-llH COOLANT MUST8£ REPLACE D!CCOROIIIG 10 IIAIUEMNCE MINDERSUI roof. 5, DI Al
10 rEAIIS HICHEIER COMES FI RST. IHER!AFTEREVERY 5 YEARS.
EN MIOING OR REPLACINGTHE COOLA!il , ALWAIS UIE Ho,d, RrCOMME DEO mum LllJiG-l!FE ANl !-FR(UE/C00 1
TYPE z. ms COOL\Jil IS PR£-MIUO W!TH50%DIST!LL!D WATER. II ODES NOT REQIJ!R£ ANY ADOil!OUl N!Xl6.
I> rm DILUTE THE COOLANT , OR THE l!F( OF IHE mINE 11111 BE SERI OUS[ YSH AIENEO .
I> mu OR ADD m COOLANT Ar !HE RlS!RiE TANX, N
OT THE ~D IATOR.
I> FOR FURTHER INfOR/1,\TlOl! ON THE COOL!~GSYmH, READ m O',N(R 'S MANUAL OR cim W
ITH IOOR !1nd1 O(Al(R .
I> Tl!(
I>
LOAD£D 1/H TESTING OF THIS VEHICLE HUST Bf CONDUCTED ON A FOUR-WHEEL ORIYE SPEED
SYNCHRONIZED OYNAMOMETER. OTHERWISE, ANON-LOADED TEST PROCEDURE MUST BE PERFORllfD.
"-
A/C Label Inspection and Replacement
NOTE: Each vehicle should only have 1 A/C label attached to the hood, but because of a change during
production, there are 2 different options.
1. Open the hood.
2.
Make sure one of the two A/C labels shown below is present on the hood.
•
•
If the label is present, go to Tire Label Inspection and Replacement.
If the label is missing, apply a new label:
Using alcohol and a clean shop towel, clean the hood area where the A/C label is placed. Allow the
surface to dry.
Peel off the backing from the A/C label, and apply it to the hood. Press the label firmly to make sure it
sticks, then go to Tire Label Inspection and Replacement.
There are 2 different label options ,
but each vehicle should only have one label attached .
A
A CAUTION
CAUTION SYSTEM CON TAJ NS REFRIGERANT
R-13•• UNDER HIGH PRESSURE.
TO BE SERVICEO ONLY BY QUALIFIED
PERSONNEL
Follow Instructions in the service manual.
AIR CONDITIONER SYSTEM
REFRIGERANT: R-134a (SAE J639)
REC. CHARGE: MAX 0.4S5kg MIN 0.405kg
OIL TYPE: ND-OILB (PAG)
~
17W
~
Hon