T-SB-0071-14

August 7, 2014
T-SB-0071-14
Roof Rack Cross Bar & Leg Cover Installation During PDS
Service
Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
YEAR(S)
MODEL(S)
2015
Land Cruiser
ADDITIONAL INFORMATION
Introduction
To avoid damage to the roof rack cross bars during transportation, the 2015 model year Land Cruiser
roof rack cross bars have been placed inside the vehicle at the assembly plant.
Install the roof rack cross bars during Pre-Delivery Service (PDS) according to the following
procedure.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
Installation Procedure
1. Loosen the adjustment knobs on each cross
bar joint.
Figure 1..
© 2014 Toyota Motor Sales, USA
Page 1 of 3
August 7, 2014
T-SB-0071-14
Page 2 of 3
Roof Rack Cross Bar & Leg Cover Installation During PDS
Installation Procedure (Continued)
2. Slide the cross bar joints into the grooves of the
right and left roof rack rails with the arrow mark on
each cross bar joint facing forward.
Figure 2..
NOTE
There is a possibility that the cross bars
will create wind noise if they are installed
backwards.
1
Front
2
Arrow Mark
3. Position the front and rear cross bars so that they are parallel to each other.
AREA
MEASUREMENT
Figure 3.
A
250 mm (9.84 in.)
B
295 mm (11.6 in.)
Then securely tighten the knobs on each cross bar (A = A’, B = B’).
NOTICE
If the knobs are NOT tightened securely, the knobs may come loose and rattle or possibly
fall off the vehicle.
© 2014 Toyota Motor Sales, USA
T-SB-0071-14
August 7, 2014
Roof Rack Cross Bar & Leg Cover Installation During PDS
Installation Procedure (Continued)
4. Install the right and left rear roof rack leg covers
in the following sequence (labeled in Figure 4).
Figure 4..
A. Insert the tab at the front of the cover into the
roof rack rail.
B. Place the cover on the leg and align the rear
part of the cover. Do NOT press down.
C. Press the cover claws facing the outside of the
vehicle into place.
D. Press the cover claws facing the inside of the
vehicle into place.
NOTICE
Do NOT press on the claws facing the
outside of the vehicle at the same time you
are pressing on the claws facing the inside.
The leg cover may be damaged.
1
Outside
2
Rear
5. Check that the covers are installed securely.
© 2014 Toyota Motor Sales, USA
Page 3 of 3