07-111-16

ATTENTION:
CLAIMS PERSONNEL q
IMPORTANT - All
Service Personnel
Should Read and
Initial in the boxes
provided, right.
SERVICE MANAGER
© 2016 Subaru of America, Inc. All rights reserved.
GENERAL MANAGER q
PARTS MANAGER
q
q
SERVICE BULLETIN
APPLICABILITY: 2015-2017MY WRX and STI Models
SUBJECT: Headlamps- Design Change to Prevent
		 Moisture Intrusion
NUMBER: 07-111-16
DATE: 07/19/16
INTRODUCTION:
This bulletin announces a design change to the headlamp assembly to improve sealing and prevent
moisture intrusion. This condition may result from a slight misalignment of the attaching points
during the headlamp assembly process. An improved sealing material is now being used for bonding
the outer lens to the housing.
PRODUCTION CHANGE INFORMATION:
The new headlamp assemblies were incorporated into production starting with VIN H*800014,
at the end of March, 2016.
Continued...
CAUTION: VEHICLE SERVICING PERFORMED BY UNTRAINED PERSONS COULD
RESULT IN SERIOUS INJURY TO THOSE PERSONS OR TO OTHERS.
Subaru Service Bulletins are intended for use by professional technicians ONLY. They
are written to inform those technicians of conditions that may occur in some vehicles,
or to provide information that could assist in the proper servicing of the vehicle. Properly
trained technicians have the equipment, tools, safety instructions, and know-how to
do the job correctly and safely. If a condition is described, DO NOT assume that this
Service Bulletin applies to your vehicle, or that your vehicle will have that condition.
Bulletin Number: 07-111-16; Date: 07/19/16
SUBARU OF AMERICA, INC. IS
ISO 14001 COMPLIANT
ISO 14001 is the international standard for
excellence in Environmental Management
Systems. Please recycle or dispose of
automotive products in a manner that is friendly
to our environment and in accordance with all
local, state and federal laws and regulations.
Page 1
PART INFORMATION:
Description
HEADLAMP ASSY ULA
HEADLAMP ASSY ULB
NEW Part Number
84001VA021
84001VA031
84002VA041
84002VA051
Notes
R/H w/o LED
L/H w/o LED
R/H w/ LED
L/H w/ LED
SERVICE PROCEDURE / INFORMATION:
Inspect the headlamp assemblies closely to confirm they have not been modified and that they are
Genuine Subaru (OEM) parts and not aftermarket replacement units. Photos comparing the OEM
part to examples of modified headlamps are provided below. Modified headlamps are not
warrantable.
Whenever replacing a headlamp assembly, always follow all the procedures in the applicable Service
Manual. In addition, pay close attention to the front bumper fascia R&R along with the headlamp
and fog lamp aiming procedures (where required). Replace only the affected headlamp assembly if
this concern is duplicated.
CAUTION: When replacing headlamp assemblies, always avoid touching the bulbs as skin oils will
cause damage and reduce bulb life. If you do inadvertently touch a bulb, clean it thoroughly with
isopropyl alcohol to remove any oil.
Bulletin Number: 07-111-16; Date: 07/19/16
Page 2
WARRANTY / CLAIM INFORMATION:
For vehicles within the Basic New Car Limited Warranty period or covered by an active Subaru
Added Security Gold plan, this repair may be submitted using the following claim information:
Labor Description
ONE HEADLIGHT ASSEMBLY R&R
BOTH HEADLIGHT ASSEMBLIES R&R
Labor Operation #
A916-143
A916-144
Labor Time
0.5
0.6
Fail Code
XFU-35
IMPORTANT REMINDERS:
•
•
•
SOA strongly discourages the printing and/or local storage of service information as previously
released information and electronic publications may be updated at any time.
Always check for any open recalls or campaigns anytime a vehicle is in for servicing.
Always refer to STIS for the latest service information before performing any repairs.
Bulletin Number: 07-111-16; Date: 07/19/16
Page 3