T-SB-0046-15

T-SB-0046-15
July 21, 2015
Short Pin Installation during PDS
Service
Category
General
Section
Pre-Delivery Service
Market USA
Applicability
YEAR(S)
MODEL(S)
2016
Camry, Camry HV
ADDITIONAL INFORMATION
Introduction
To minimize battery discharge during transportation and storage, the Short Pin has been
removed at the assembly plant and temporarily stored in the engine compartment Relay Block.
Reinstall the Short Pin into its original location and confirm all related Diagnostic Trouble Codes
(DTCs) are cleared during Pre-Delivery Service (PDS).
NOTE
The short pin is removed only on vehicles going to Hawaii, Puerto Rico, Saipan, Guam, and
American Samoa.
Required Tools & Equipment
REQUIRED EQUIPMENT
Techstream 2.0*
Techstream Lite
SUPPLIER
PART NUMBER
QTY
TS2UNIT
ADE
1
TSLITEPDLR01
* Essential SST.
NOTE
Only ONE of the Techstream units listed above is required.
Software version 10.10.018 or later is required.
Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE)
at 1-800-368-6787.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
© 2015 Toyota Motor Sales, USA
Page 1 of 3
T-SB-0046-15
July 21, 2015
Page 2 of 3
Short Pin Installation during PDS
Introduction
1. Remove the Short Pin from the blank space of the Relay Block in the engine compartment
and install the Short Pin in the Relay Block as shown.
Figure 1
1
Relay Block
2
Remove This Short Pin
3
Install Short Pin Here (Original Location)
NOTE
The Short Pin does NOT function as a fuse, so install it only in the position shown.
If the vehicle is stored after PDS, disconnect the negative (–) battery terminal to prevent
battery discharge. Refer to Service Bulletin No. PG001-06, “Battery Maintenance for
In-Stock Vehicles & Pre-Delivery.”
DTC Clearing Procedure
With the Short Pin removed, the occupant classification ECU and Center Airbag Sensor
Assembly (airbag ECU) may detect the interruption in battery voltage (B+) and store one or more
DTCs. Clear DTCs B1650 and B1794 after installing the Short Pin.
1. Connect Techstream to the DLC3.
2. Cycle the ignition switch to the “IG-ON” position.
© 2015 Toyota Motor Sales, USA
T-SB-0046-15
July 21, 2015
Page 3 of 3
Short Pin Installation during PDS
DTC Clearing Procedure (Continued)
3. Using Techstream, check any other codes being output.
NOTE
If any DTCs other than B1650 and B1794 are found, repair the applicable system according to
the Repair Manual.
4. Erase DTCs (B1650 and B1794) and Freeze Frame Data.
© 2015 Toyota Motor Sales, USA