T-SB-0093-16

August 2, 2016
T-SB-0093-16
Parking Assist Monitor System Initialization
Service
Category
General
Section
Pre-Delivery Service
Market USA
Applicability
YEAR(S)
MODEL(S)
2017
RAV4, RAV4 HV
ADDITIONAL INFORMATION
Introduction
The Parking Assist Monitor System assists the driver during parking and parallel parking by
displaying an image of the area behind the vehicle.
When the D/C Cut Fuse is removed or battery terminal is disconnected, the power source to the
steering angle sensor is cut off. When the D/C CUT fuse is reinstalled or the battery terminal is
reconnected, the rear view monitor will operate, but it may not display estimated course lines to
assist parking operation until the system has initialized.
Initialize the Parking Assist Monitor System after installing the D/C CUT fuse during Pre-Delivery
Service (PDS).
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
-
-
-
-
© 2016 Toyota Motor Sales, USA
Page 1 of 2
T-SB-0093-16
August 2, 2016
Page 2 of 2
Parking Assist Monitor System Initialization
Initialization Procedure
1. Start the engine/hybrid system.
2. Check if the Parking Assist Monitor System is operative by moving the shift lever to the “R”
position with the parking brake applied and the brake pedal depressed.
NOTE
If the estimated course lines are displayed on the rear view monitor, STOP, initialization is
NOT necessary.
3. Move the shift lever to the “P” position and turn the steering wheel lock to lock.
4. Move the shift lever to the “R” position.
When the estimated course lines are
displayed on the rear view monitor as
shown, initialization of the Parking Assist
Monitor System has been completed.
NOTE
If the estimated course lines are still NOT
displayed after performing these steps,
refer to the Repair Manual.
© 2016 Toyota Motor Sales, USA