PIP5025E
Service Bulletin Details
Public Details for: PIP5025E
This preliminary information communication provides information to the technician about vehicles that have excessive oil consumption and/or that they have to add oil between oil changes. Technician should reprogram the engine control module
Bulletin No.: PIP5025E Date: Jan-2013 Subject: Excessive Oil Consumption - Install Updated ECM Calibration and Perform Oil Consumption Test Models: 2010-2011 Buick Lacrosse 2011 Buick Regal 2010-2011 Chevrolet Equinox 2010-2011 GMC Terrain with 2.4L Engine (RPO LAF) This PI was superseded to update recommendation field. Please discard PIP5025D. The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI. Condition/Concern Some customers may complain of excessive oil consumption and/or that they have to add oil between oil changes. Recommendation/Instructions If this complaint is encountered, perform an oil consumption test by following the latest version of bulletin 01-06-01-011. Before starting the oil consumption test, reprogram the ECM with the latest TIS2web calibrations to adjust the engine oil life monitor to a maximum of 7,500 miles (12,070 KM), inspect for any obvious oil leaks that may explain the oil consumption complaint, and repair as necessary. Important: When checking the oil level with the oil dipstick design shown below, please note that the oil volume per notch is not linear due to the shape of the block. The upper notches (relative to the top of the handle) equal .24 quart (.227 L) between each notch while the lower notches only equal .14 quart (.132 L) between each notch. As a result, no oil will appear on the dipstick if it is low on oil by approximately 1.25 quarts (1.18L) or more. When determining the oil consumption rate, the oil volume added to return it to the starting location is the total amount of oil consumed. The consumption rate must be documented on a repair order. If the oil consumption test indicates that the rate of consumption is greater than 1 quart (.946 L) of oil every 2,000 miles (3,200 KM), note the oil consumption rate, the date that the ECM was reprogrammed, and any repairs/diagnosis that you have performed. Dealers who are required to contact PQC for engine replacement authorization should call PQC with this PI number, the engine unit numbers, and engine replacement cost as outlined in the latest version of 02-07- 1 30-029 to determine if engine replacement is required. The engine unit numbers should be located on a white bar code sticker on the front of the engine and/or stamped near the engine oil filter. Important: If engine replacement is required, it may or may not be necessary to swap/replace the intake camshaft and intake camshaft actuator sprocket on 2010 models depending on the engine part number received. As a result, it is suggested to review the latest version of PI0865 and/or follow the related instruction sheet that should be attached to the engine crate to determine if additional parts need to be installed or swapped from the original engine to the replacement engine before it is installed. To complete the repairs, ensure that the latest ECM calibrations have been installed to adjust the engine oil life monitor to a maximum of 7,500 miles (12,070 KM) as well. Warranty Information For vehicles repaired under warranty use: Labor Operation Description Labor Time J6350 Engine Control Module Reprogramming with SPS Use Published Labor Operation Time Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed. GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information. WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION 2