PI1358
Service Bulletin Details
Public Details for: PI1358
This preliminary bulletin provides a procedure to repair the carpet by installing retainers, from pulling loose from the drivers body hinge pillar trim panel.
- 2015 - 2014 - 2013 - 2012 - 2011 - 2010 -
Models from 2015
2015 CHEVROLET EQUINOX |
2015 GMC TERRAIN |
Models from 2014
2014 CHEVROLET EQUINOX |
2014 GMC TERRAIN |
Models from 2013
2013 CHEVROLET EQUINOX |
2013 GMC TERRAIN |
Models from 2012
2012 CHEVROLET EQUINOX |
2012 GMC TERRAIN |
Models from 2011
2011 CHEVROLET EQUINOX |
2011 GMC TERRAIN |
Models from 2010
2010 CHEVROLET EQUINOX |
2010 GMC TERRAIN |
File in Section: Service Bulletin Bulletin No.: Date: PI1358 November, 2014 PRELIMINARY INFORMATION Subject: Carpet Pulls Loose from Under Driver Side Body Hinge Pillar Trim Panel Models: 2010-2015 Chevrolet Equinox 2010-2015 GMC Terrain Condition/Concern 3998334 Some customers may comment that the driver side carpet pulls away from the lower left body hinge pillar trim panel (kick panel). Recommendation/Instructions Technicians should remove the lower left body hinge pillar trim panel (kick panel) and install push pins to the area shown following the steps below: 3998336 1. Remove the body hinge pillar trim panel. 4006834 2. Pull back the carpet to expose the driver footrest. 3. Remove the two mounting nuts and remove the footrest. 4006835 4. With the footrest on a bench, turn over and mark the first and fourth “box” of the center row with a paint pen as shown. 5. Using a 1/4” (6.35 mm) drill bit, drill two holes in the center of the marks. 4006836 6. Install the footrest and the two mounting nuts. 4006837 7. Place two rivets in the holes drilled and pull the carpet gently over the rivets. 4006838 8. Push the carpet over the rivets and punch through the carpet as shown. 4006839 9. Lift the carpet back up, remove the rivets and use a punch to open the holes of the carpet to allow push pins through. 4006840 10. Install the push pins through each hole. Note: Trimming the jute around the push pins helps with installation. 4006841 11. Install the carpet to the driver footrest using the push pins. 12. Install the body hinge pillar trim panel. Parts Information Part Number Description Quantity 11569663 Rivet 2 22718305 Push Pin 2 Warranty Information For vehicles repaired under warranty, use: Labor Operation Description Labor Time 1080198* Install Retainers to Retain Carpet 0.5 hr *This is a unique Labor Operation for Bulletin use only. It will not be published in the Labor Time Guide.