PIC5733A

Bulletin No.: PIC5733A
Date: Dec-2015
Subject:
Lock Indicator Flickers And Unable To Clear DTC B2625 After Repairs Are Completed
Models:
2013 Cadillac ATS
This PI has been updated to revise the Recommendations section. Please discard all copies of PIC5733.
The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
Condition/Concern
A technician may find that the DTC B2625 Symptom Code 02 remains as a Current DTC even though repairs have been completed. When this occurs, the
Lock indicator lamp will be flickering.
Recommendation/Instructions
Important: Do not replace the BCM for this concern
The DTC can be successfully cleared and the Lock Indicator lamp will stop flickering by using the following procedure after correcting the cause of the B2625
DTC:
1.
Disconnect the battery negative terminal for 30 seconds.
2.
Reconnect the battery. The DTC will be stored as History and you will now be able to use the Clear DTC command to erase the DTC.
Warranty Information
For wiring repairs covered under warranty, please refer to latest version of bulletin 10-00-89-005 for warranty information on wire/connector repairs.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the
remaining steps do not need to be performed.
GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may
occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools,
safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that
your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.
WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION
1