A191668 2042328-
Service Bulletin Details
Public Details for: A191668 2042328-
The red coolant light is illuminated , indicating that the coolant temperature is too high or that the coolant level is too low. The engine speed governing light is illuminated with the message " engine speed maximum xxxx rpm". To prevent t
- 2015 - 2014 - 2013 - 2012 - 2011 - 2010 - 2009 - 2008 -
Models from 2015
| 2015 AUDI RS 5 |
Models from 2014
| 2014 AUDI RS5 |
Models from 2013
| 2013 AUDI RS5 |
Models from 2012
| 2012 AUDI A8 |
| 2012 AUDI S5 |
Models from 2011
| 2011 AUDI A8 |
| 2011 AUDI S5 |
Models from 2010
| 2010 AUDI S5 |
Models from 2009
| 2009 AUDI S5 |
Models from 2008
| 2008 AUDI S5 |
Technical Service Bulletin 19 Thermostat, electric fault (DTC P0599, P0597, P2181) 19 16 68 2042328/2 March 9, 2016. Supersedes Technical Service Bulletin Group 19 number 15-63 dated October 29, 2015 for reasons listed below. Model(s) Year VIN Range Vehicle-Specific Equipment S5 2008 - 2012 All 4.2 FSI RS5 2013 - 2015 All 4.2 FSI A8 2011 - 2012 All 4.2 FSI Condition REVISION HISTORY Revision Date Purpose 2 - Revised Warranty (Changed Damage Code; added GFF time) 1 10/29/2015 Initial publication One or more of the following conditions is present: • The red coolant light is illuminated (Figure 1), indicating that the coolant temperature is too high or that the coolant level is too low. • The engine speed governing light is illuminated (Figure 1) Figure 1. Engine speed governing light (left) and with the message “Engine speed maximum XXXX rpm”. red coolant light (right). To prevent the engine from overheating, the engine speed is automatically limited to the displayed maximum. • One of the following DTCs is stored in the engine control module (ECM), J623 (address word 01): • DTC P059700 (Thermostat for map-controlled engine cooling F265, circuit open) • DTC P059900 (Thermostat for map-controlled engine cooling F265, short circuit to positive) • DTC P218100 (Fault in cooling system) Technical Background Tolerances of opening spring in thermostat cause the condition. © 2016 Audi of America, Inc. Page 1 of 3 All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin Production Solution Modified coolant thermostat housing. Service If one of the DTCs listed in the Condition is stored, replace the coolant thermostat housing for map-controlled engine cooling (Figure 2). It is not necessary to replace the complete coolant pump. Figure 2. Coolant thermostat housing for map-controlled engine cooling. Warranty Claim Type: Use applicable claim type. If vehicle is outside any warranty, this Technical Service Bulletin is informational only. Service Number: 1955 Damage Code: 0010 Labor Operations: Thermostat housing remove+reinstall 1955 1919 (For S5) 160 TU (For S5) (Includes all operations) 1955 1921 (For RS5) 190 TU (For RS5) 1955 1919 (For A8) 190 TU (For A8) GFF – check and clear faults codes 0150 0000 10 TU Road test prior to service procedure No allowance 0 TU Road test after service procedure 0121 0004 10 TU Diagnostic Time: Technical diagnosis at dealer’s discretion (Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details) Claim Comment: As per TSB #2042328/2 All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual. Claims are subject to review or audit by Audi Warranty. © 2016 Audi of America, Inc. Page 2 of 3 All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. Technical Service Bulletin Required Parts and Tools Part Number Part Description Quantity 079121115BB Map controlled engine cooling thermostat F265 1 G 013A8J1G Coolant additive 1 Outside material Distilled water (obtain locally) As needed (Max $10.00) Tool Number Tool Description VAS 6096 Cooling system charge unit VAS 6208 Drip tray T10007A Refractometer Additional Information All parts and service references provided in this TSB (2042328) are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information. © 2016 Audi of America, Inc. Page 3 of 3 All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher.