5NP-H5D3F-12

GROUP
CAMPAIGN
Technical Service Bulletin
SUBJECT:
DATE
NOVEMBER 2016
NUMBER
16-01-061
MODEL(S)
ELANTRA (ADa)
OVERHEAD CONSOLE LAMP BULB SOCKET REPLACEMENT
(SERVICE CAMPAIGN T1F)
 IMPORTANT
*****DEALER STOCK ONLY*****
Dealers must perform this Service Campaign on all affected vehicles prior to customer retail
delivery.
When a vehicle arrives at the Service Department, access Hyundai Motor America's "Warranty
Vehicle Information" screen via WEBDCS to identify open Campaigns.
Description: On certain 2017 Elantras, the overhead console lamp intermittently does not turn ON.
This bulletin provides the procedure to replace the bulb socket to correct the condition.
Applicable Vehicles: Certain 2017 Elantra (ADa)
Circulate To: General Manager, Service Manager, Parts Manager, Warranty Manager, Service
Advisors, Technicians, Body Shop Manager, Fleet Repair
SUBJECT:
OVERHEAD CONSOLE LAMP BULB SOCKET REPLACEMENT
(SERVICE CAMPAIGN T1F)
Parts Information:
PART NAME
FIGURE / PART NUMBER
QTY
BULB SOCKET ASSY
2
18643-10009NQQH
Warranty Information:
OP CODE
OPERATION
OP TIME
60CA20R0
BULB SOCKET REPLACEMENT
0.3 M/H
NOTE 1: Submit Claim on Campaign Claim Entry Screen.
NOTE 2: If a part is found in need of replacement while performing Campaign T1F and the affected
part is still under warranty, submit a separate warranty claim using the same Repair Order. If the
affected part is out of warranty, submit a Prior Approval Request for goodwill consideration prior to
performing the work.
Service Procedure:
NOTICE
Wear clean gloves when performing the overhead console lamp bulb socket
replacement to avoid contamination to the headliner.
1.
Open the sunglass holder and use a Phillips
screwdriver to remove the two screws.
TSB #: 16-01-061
Page 2 of 5
SUBJECT:
2.
OVERHEAD CONSOLE LAMP BULB SOCKET REPLACEMENT
(SERVICE CAMPAIGN T1F)
Carefully pull the overhead console lamp
assembly down, and use a flathead
screwdriver to press against the side clips.
Location of side clips
Use a flathead screwdriver to press
against the side clip
3.
After the console is lowered, remove both
bulb sockets on the backside by twisting
them counter clockwise. (As shown in
picture)
TSB #: 16-01-061
Page 3 of 5
OVERHEAD CONSOLE LAMP BULB SOCKET REPLACEMENT
(SERVICE CAMPAIGN T1F)
SUBJECT:
4.
Install the two new bulb sockets by twisting
them clockwise.
5.
Inspect the overhead console lamp
assembly side clips to ensure they are not
deformed.
If the side clips are deformed, use a flathead
screwdriver to bend the clips into the correct
position.
!
CAUTION
If the side clips are deformed, rattles
can occur with the bracket or a gap
between the headliner and the
overhead console lamp assembly.
6.
Reinstall the overhead console lamp
assembly into the headliner and tighten the
two screws.
TSB #: 16-01-061
Page 4 of 5
SUBJECT:
OVERHEAD CONSOLE LAMP BULB SOCKET REPLACEMENT
(SERVICE CAMPAIGN T1F)
6a. If the two screws slip during the tightening
process, ensure the overhead console
assembly is firmly pressed against the roof
and the holes are aligned.
By pressing the overhead console
assembly against the roof, it will hold the
clip in place through the two ridges.
Clip hole is aligned with the overhead
console assembly.
7.
Confirm the overhead console light is
operating normally.
TSB #: 16-01-061
Page 5 of 5