ITB16-044a

Classification:
Reference:
EM16-007a
Date:
ITB16-044a
February 7, 2017
2016-2017 Q50, 2017 Q60, AND 2017 QX30 WITH 2.0L TURBO ENGINE;
CARTRIDGE-STYLE OIL FILTER
This bulletin has been amended. Information about how to remove a stuck oil filter from the filter housing
has been added. No other changes have been made. Please discard previous versions of this bulletin.
APPLIED VEHICLES:
2016-2017 Q50 (V37)
2017 Q60 (V37)
2017 QX30 (H15)
APPLIED ENGINE:
2.0L Turbo
SERVICE INFORMATION

The Applied Vehicles are equipped with a cartridge-style oil filter.

The oil filter may be difficult to remove from the filter housing. If this should occur, pull the filter straight
out, being careful not to bend the housing. If the filter cannot be pulled out of the housing, follow the
removal instruction on page 2.

The filter housing may be damaged or broken if not handled with care.

If the filter housing is damaged or broken, it must be replaced.
NOTE:
 If the tip of the filter housing breaks off inside the front cover of the engine, use needle-nose pliers
to remove the piece(s) to prevent debris from entering the oil passages when the engine is started.
 If a replacement filter housing is needed, make sure to lubricate the o-rings and neck of the filter
housing prior to installation.
Filter housing may be
damaged or broken if not
handled with care
Figure 1
Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that
a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this
applies to your vehicle.
1/2
Remove a Stuck Oil Filter from the Filter Housing
1. Using a suitable knife, cut the white seal as shown in Figure 2.
CUT HERE
CUT HERE
Seal
Oil filter
Filter
housing
Figure 2
2/2
ITB16-044a