24-002-16

NUMBER:
GROUP:
DATE:
24-002-16
Heating & Air
Conditioning
January 09, 2016
This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system,
or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC.
THIS BULLETIN SUPERSEDES SERVICE BULLETIN 24-007-15, DATED NOVEMBER
07, 2015, WHICH SHOULD BE REMOVED FROM YOUR FILES. ALL REVISIONS ARE
HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE AN UPDATED PART NUMBER.
HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS
AVAILABLE BY SELECTING “HELP” THEN “HELP CONTENTS” AT THE TOP OF
THE wiTECH DIAGNOSTIC APPLICATION WINDOW.
THE wiTECH SOFTWARE IS REQUIRED TO BE AT THE LATEST RELEASE BEFORE
PERFORMING THIS PROCEDURE.
SUBJECT:
Air Conditioning Inoperative
OVERVIEW:
This bulletin involves replacing the Manual Climate Control Module.
MODELS:
2016
(FB)
Fiat 500X
2015
(BU)
Jeep Renegade
NOTE: This bulletin applies to vehicles within the following markets/countries:
NAFTA, EMEA.
NOTE: This bulletin applies to vehicles built on or before June 17, 2015 (MDH
0617XX).
SYMPTOM/CONDITION:
A small number of customers may experience the loss of air conditioning operation (A/C
compressor will not turn on).
24-002-16
-2-
DIAGNOSIS:
Using a Scan Tool (wiTECH) with the appropriate Diagnostic Procedures available in
TechCONNECT, verify all systems are functioning as designed. If DTCs or symptom
conditions, are present other than the symptom condition listed above, record the issues
on the repair order and repair as necessary before proceeding further with this bulletin.
If the customer describes the symptom/condition listed above, perform the Repair
Procedure.
PARTS REQUIRED:
Qty.
Part No.
Description
1
**6CW62LXHAA**
Climate Control Module (FB)
1
6CY58LXHAA
Climate Control Module (BU)
REPAIR PROCEDURE:
1. Replace the Manual Climate Control Module.Refer to the detailed service procedures
available in DealerCONNECT> TechCONNECT under: Service Info> 24 - Heating and
air Conditioning > Controls > CONTROL, A/C and Heater > Removal and Installation.
2. Clear all DTCs that may have been set in any module due to reprogramming. The
wiTECH application will automatically present all DTCs after the flash and allow them
to be cleared.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation
No:
24-50-10-9B
Description
Module, Heating Ventilation
Air Conditioning (HVAC) Replace
(2 - Skill Level)
FAILURE CODE:
ZZ
Service Action
Skill Category
Amount
07 - A/C and Heating 0.4 Hrs.