TT261703
Service Bulletin Details
Public Details for: TT261703
Adblue heater reset information that is not available in the test plan or repair manual. Initialization necessary to after repairs.
- 2015 -
Models from 2015
2015 VOLKSWAGEN BEETLE |
2015 VOLKSWAGEN GOLF |
2015 VOLKSWAGEN GOLF SPORTWAGEN |
2015 VOLKSWAGEN JETTA |
2015 VOLKSWAGEN PASSAT |
Technical Tips Technical Tip Topic 26-17-03TT - 2015 Gen III TDI AdBlue® Light, SCR Light Will Not Reset Market area United States 444 Volkswagen of America, Inc. (6444) Brand Volkswagen Date March 03, 2017 Condition ATTENTION: THIS IS A TECH TIP, NOT A TECHNICAL BULLETIN AS TITLED. TECH TIPS ARE NOT ASSOCIATED WITH WARRANTY CLAIMING. SCR Line Heater Circuit Re-initialize Model(s) Year Eng. Code Trans. Code VIN Range From VIN Range To Golf, Passat, Beetle, Jetta, Sportwagen 2015 2.0l TDI CRUA/CVCA All All All Technical Background 2015 Gen III TDI AdBlue® Light, SCR Light ON, may set DTC P208B or display no faults due to system repair. SCR line heater circuits need to be re -initialized in the ECM. Heater circuit 1 for SCR tank and pump, heater circuit 2 SCR lines -Z104- need to be selected in output diagnostic mode through control module OBD. Activating the SCR heater circuits clears learned values in the ECM allowing the SCR light to be reset with no parts replacement needed. Service Using O.D.I.S.: 1) 2) 3) 4) 5) 6) 7) 8) Navigate to control module OBD (Can be performed KOEO at this point) Output Diagnosis Adaptation heater circuit and adaptation heater circuit 2 Click forward button, bottom right, 2 times. From measured values list, select IDE: 03133, 03137, 03134 and 03138 Click forward button again. Activate both heater circuits, verify amperage and voltage change. Start the vehicle, go to measured value for particle filt.inlet temp.sens. 1 bank 1, raw value IDE: 07716. Sensor must be at 150°C (run until this temp is met or exceeded) 9) Go to Guided Functions, Adap. value, SCR system. 10) Select Resetting adapt. values of reduction agent sys.,comp.change. Note: Test may take up to 2 minutes with vehicle running. 11) Select MV IDE: 11220 SCR current status and IDE: 10241 Reducing agent pump module relative press. calculated. Note: Vehicle must be running and MV particle filt.inlet temp.sens. 1 bank 1, raw value IDE: 07716 still at least 150°C. 12) When IDE: 11220 SCR current status goes to pressure control and IDE: 10241 Reducing agent pump module relative press. calculated reads approximate 6 bar, system is operating to specification. 13) Road test vehicle to ensure AdBlue light goes out. 1 Technical Tips Additional Information Revision History Revision Number Released Date Reason For Update 2047070/1 3/3/17 Original publication. © 2017 Volkswagen Group of America, Inc. All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Volkswagen Group of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the publisher. 2