GST-TSB-17-001

ATTENTION: This Technical
Service Bulletin was issued by
Gulf States Toyota, Inc.
For Toyota Dealers located in the Gulf States Toyota Region:
Please refer to GST Dealer Daily to obtain instructions on how to
order parts and submit a warranty claim (If applicable).
For Toyota Dealers NOT located in Texas, Oklahoma,
Mississippi, Arkansas or Louisiana: For Repair Authorization,
Parts Ordering, and Warranty Claims please contact GST
Accessory Technical Support at 1-800-444-1074.
Thank you for your continued support.
GST-TSB-17-001
March 23, 2017
Service Category:
Section:
Technical Service Bulletin
Vehicle Interior
Theft Deterrent /Keyless Entry
Market:
USA
Alarm Triggering While Driving
Applicability
YEAR(S) MODEL(S)
20132016
2017
20162017
RAV4
RAV4
Corolla
INSTALLED ACCESSORY INFORMATION
DESCRIPTION
Premium Security
System
Premium Security
System
Premium Security
System
ACCESSORY LIO CODE
KIT PART NUMBER
S6
00012-V1320-01
S6
00012-V1620-01
S6
00012-11620-01
Introduction
Some 2013-2017 RAV4 and 2016-2017 Corolla vehicles equipped with the GST Premium Security System
accessory may exhibit improper function of the alarm, including a triggering of the alarm while driving, if the
Power Outlet No.1 fuse is open. The following repair procedure will address this condition.
Parts Information
Vehicle
Kit Part Number
Component Needed for Repair
RAV 4
Corolla
00012-01520-22
00012-01520-22
24-26 Gauge Black T-Tap
18-22 Gauge Red T- Tap
Quantity Required
per Vehicle
1
1
Part Description
15A Mini-Fuse
Quantity
1
Vehicle
RAV 4 and Corolla
Part Number
90982-09022
NOTE
NOT all items from the Kit will be needed for the repair.
2
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
Warranty Information
This repair is covered under the basic vehicle warranty. This warranty is in effect for 36 Months or
36,000 Miles, whichever occurs first from the vehicle’s In-service date.
GST Installed Product
COROLLA
RAV 4 2017
2016-2017
B17023
B17022
Model
RAV 4
2013-2016
Operation
Code
B17021
OFP
00012-V1320-01
00012-V1620-01
00012-11620-01
Labor Time
0.5
0.5
0.5
DIO
B17024
00012-V1320-01
00012-V1620-01
00012-11620-01
0.5
Repair Procedure
1. Disconnect Negative Battery Terminal.
2. Locate and inspect Power Outlet No.1 Fuse.
Is Power Outlet No.1 Fuse Open?
 Yes – Replace 15A fuse and proceed to Step 3
 No – This TSB does not apply
RAV4 Repair Procedure
3. Remove the fuse box opening cover by detaching the 8 clips illustrated in Fig.1
NOTE
Apply protective tape per Fig. 1 to avoid mutilation to vehicle.
Fig.1
3
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
RAV4 Repair Procedure (cont’d)
4. Locate the Instrument Panel J/B Assembly
a. Locate connector 3D
3D
Pin 15 - (YELLOW)
Ignition
(7.5A HTR)
NEW
Pin 14 - (WHITE)
Ignition
(15A Power Outlet
No.1)
OLD
5.
6.
7.
8.
Disconnect the insulated female connector from the Red t-tap on PIN 14 Wire (White)
Reference Page 11 on T-Tap Installation Guide
Install Black T-Tap onto PIN 15 Wire (Yellow)
Re-connect insulated female connector onto installed Black T-Tap
NOTE
DO NOT REMOVE the RED T-TAP from PIN 14 Wire. It must remain
on vehicle after repair is completed
4
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
RAV4 Repair Procedure (cont’d)
9. Re-install the fuse box opening cover
10. Re-connect negative battery terminal and torque to 48 in./lbs
11. Test Alarm System for proper function as listed on Page 10
Corolla Repair Procedure
16MY Corolla
3. Remove Fuse box opening cover

Remove cover per Fig.1 and bolt per Fig.2
FIG. 2
FIG.1
5
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
Corolla Repair Procedure (cont’d)
17MY Corolla
3. Remove No.1 Meter Hood Cluster


Apply protective tape to the area shown in Fig. 3
Using molding remover, disengage the 3 clips and Remove the No.1 Meter Hood
Cluster shown in Fig. 4
A. Disconnect the Front Door Opening Weatherstrip LH
B. Remove Instrument Side Panel LH shown in Fig. 5.

Using molding remover, disengage the 6 clips in the direction indicated by the arrow
C. Remove No.1 Instrument Panel Register Assembly shown in Fig. 6.

Disengage the 4 clips and Remove the No.1 Instrument Panel Register Assembly
Fig. 3
Fig. 4
6
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
Corolla Repair Procedure (cont’d)
Fig. 5
Fig. 6
D. Remove Fuse box opening cover

Remove cover per Fig.7 and bolt per Fig. 8
FIG. 8
FIG. 7
7
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
Corolla Repair Procedure (cont’d)
4. Locate the Instrument Panel J/B Assembly
a. Locate connectors 3C and 3D
3D - Pin 14 - (GRAY)
(7.5A Audio System)
NEW
3D
3C
3C - Pin 4 - (GRAY)
(15A Pwr Outlet No.1)
OLD
8
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
Corolla Repair Procedure (cont’d)
5. 16MY Corolla ONLY - On Connector 3C – Is there a T-Tap present on PIN 4?
 Yes – Proceed to Step 6
 No – This TSB does not apply
6. On Connector 3C - Disconnect the insulated female connector from the Red t-tap on PIN 4
Wire (Gray)
7. Reference Page 11 on T-Tap Installation Guide
8. On Connector 3D - Install Red T-Tap onto PIN 14 Wire (Gray)
9. Re-connect insulated female connector onto installed Red T-Tap
NOTE
DO NOT REMOVE the RED T-TAP from PIN 4 Wire. It must remain
on vehicle after repair is completed
10. Re-install the fuse box opening cover
11. Re-connect negative battery terminal and torque to 48 in./lbs.
12. Test Alarm System for proper function as listed on Page 10
9
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
10
GST-TSB-17-001
March 23, 2017
Technical Service Bulletin
T-TAP Reference Information
11