MY 2017 TT-TTS C
Service Bulletin Details
Public Details for: MY 2017 TT-TTS C
Vehicle preparation section: added: set the service intervals to 10k instead of 5k during pdi or existing 2017 vehicles that are set incorrectly 1. Click on the ?Special functions? Tab 2. Scroll down to ?Maintenance? 3. Select the 17
- 2017 -
Models from 2017
2017 AUDI TT |
2017 AUDI TT ROADSTER |
2017 AUDI TTS |
2017 TT/TTS Coupe Audi Pre-Delivery Inspection Stock No. Dealer Number R.O. No. VIN Road test mileage out Road test mileage in Reminders All items must be completed prior to customer delivery by an Audi technician Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection ALL PDI function tests must be run in Guided Fault Finding (GFF) only. Do NOT use Guided Functions for any PDI related test as these will not be uploaded to the Paperless Server. Refer to the Special functions tab of ODIS Diagnosis for using GFF for PDI function tests It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF and also to ensure SVM sees all control units during the SVM check vehicle configuration For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information Vehicle Preparation Under the Hood Inspection (continued) Check Elsa for open campaigns and updates Check engine oil level* Deactivate vehicle transport mode* This step must be performed with the engine off, and ignition on Check all fluid levels and top off if necessary Set adaption channel to enable CD Ripping (if equipped with NAV)* Check all key buttons and features* Set service reminder* Lighting and Windshield Perform any open campaigns* Test exterior lighting functions Set the service intervals to 10k instead of 5k during PDI or existing 2017 vehicles that are set incorrectly Install wiper blades Exterior Test windshield washers 1. Click on the “Special functions” tab 2. Scroll down to ‘Maintenance’ Trunk Inspection 3. Select the 17 - inspection with oil change - 10,000 miles, USA function test Verify trunk is operational 4. Perform the function test, but make sure you select “USA” as the country variant and when the question “Which service display should be reset?” comes up, select #2 (Oil service display and inspection service display). Install wheel bolt cover removal tool from PDI kit into trunk tool kit* 5. Then the MM indicator should now properly display the following values Verify operation of emergency release handle Verify tool kit is installed securely in luggage compartment Set spare tire pressure* Interior − Next oil service in 10,000 miles / 365 days Verify operation of all seat belts and latches − Next inspection service at 20,000 miles / 730 days Check operation of window, lock, and seat controls* Under the Hood Inspection Check battery clamps for proper torque* Perform a battery test* Effective 10-27-2016-US Version 1.1 Check rear view mirror operation* Inspect mirrors for proper operation* Verify operation of all interior lights Verify operation heated seats PRE-DELIVERY INSPECTION (PDI) | 1 2017 TT/TTS Coupe Audi Pre-Delivery Inspection Interior (continued) On-Hoist Inspection (continued) Verify proper operation of climate control* Inspect wheel bolts for proper torque* Inspect operation of all power outlets* Install wheel locks (if equipped) Verify operation of front Passenger Occupant Detection System Install wheel bolt covers and center caps as supplied* Set and store tire pressures for either sold vehicle OR stock inventory vehicle* Settings Verify operation of MMI touch pad Driving Performance Set Time source setting to “GPS” and set Auto daylight savings time to “on.”* Check horn operation Verify hold and release of electronic parking brake Verify and set language and Measurement Units* Verify engine performance and acceleration* Verify speech dialogue system* Verify transmission operation, including shift paddles Set dealership location in navigation (if equipped)* Test drive vehicle applying brakes several times* Check steering/tire alignment Media / Radio / SAT Verify rear spoiler functionality Verify operation of both USB ports and aux. input Check for squeaks, rattles and wind noise Verify operation of CD/DVD player Calibrate rear view mirror* Insert SD card and test function of all slots Verify quality of radio reception in AM/FM/SiriusXM bands Program the presets to local stations Driver Assistance Audi connect (USA ONLY) (if equipped) Verify all cruise control functions Verify Audi connect Information Packet is present (if equipped)* Verify Audi side assist functionality (if equipped) Connect the dealer demo SIM card to verify system connects to mobile network* Turn on the wireless network (if equipped)* Check Wi-Fi hotspot functionality* Verify operation of parking system* Activate NAV and follow directions back to dealership (if equipped) Post-Road Test Inspection Enable Google Earth (if equipped)* Interrogate fault memory and print Diagnostic Log Ensure the yellow tire pressure tag is installed on the steering wheel On-Hoist Inspection Remove transport suspension blocks (follow ELSA instruction) Apply Inventory Maintenance Sticker Check steering, boots, brake system, hoses, tires and wheels for damage Install showroom charger to ensure battery remains charged at all times Check underside of vehicle for fluid leaks and loose components Technician I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and Quality Standards, and has met the standards for Perfect Delivery. Technician Signature Effective 10-27-2016-US Version 1.1 Last 8 of VIN Completion Date PRE-DELIVERY INSPECTION (PDI) | 2