A011708 2041097-

01 MIL on (DTC P0011 and/or P0021 - camshaft position)
01 17 08 2041097/3 April 3, 2017. Supersedes Technical Service Bulletin Group 01 number 16-71 dated July 27,
2016 for reasons listed below.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
S6, S7, RS
7,
A8, S8
2013 - 2014
All
4.0 TFSI
Condition
REVISION HISTORY
Revision
Date
Purpose
3
-
Revised Warranty (Updated Damage Code)
2
08/01/2016
Revised Warranty (Added GFF time)
1
07/01/2015
Initial publication
 MIL on.
 Customer may report that the engine runs irregularly.
One of the following DTCs is stored in the engine control module (ECM), J623 (address word 0001):
 DTC P001100 (A camshaft position (bank 1) timing over-advanced or system performance)
 DTC P002100 (A camshaft position (bank 2) timing over-advanced or system performance)
Page 1 of 4
© 2017 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Technical Background
 On the camshaft adjustment valve, the filter element can
loosen (Figure 1).
 There is no consequential damage from loosened particles
in the oil circuit. They are gathered by the oil filter.
Figure 1. Two top filters are okay, bottom
filter is missing.
Production Solution
Optimized control valve production.
Service
1. The camshaft adjustment valve is fitted in
four different positions. Check the
affected camshaft adjustment control
valve (see DTC entry). The following list
shows which component is affected,
based on event entry:
 N205 – cylinder bank 1, inlet side
 N318 – cylinder bank 1, exhaust side
 N208 – cylinder bank 2, inlet side
 N319 – cylinder bank 2, exhaust side
2. Remove connector (Figure 2) from
control valve with DTC.
3. Remove bolt (Figure 2) from control
valve with DTC, then remove valve.
Figure 2. Connector (1) and bolt (2) to be
removed from affected control valve.
Page 2 of 4
© 2017 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
4. Install O-ring on new control valve.
Replace hex collard bolt and tighten new
bolt to 5 Nm.
Warranty
Claim Type:
 110 up to 48 Months/50,000 Miles.
 G10 for CPO Covered Vehicles – Verify Owner.
 If vehicle is outside any warranty, this Technical Service Bulletin is informational
only.
Service Number:
1585
Damage Code:
0016
Labor
Operations:
Control valve remove + reinstall
1585 1921
50 TU
1585 1922
50 TU
GFF – Checking and clearing fault codes.
0150 0000
20 TU
Road test prior to service procedure
No allowance 0 TU
Road test after service procedure
0121 0004
(For inlet side, bank 1 or bank 2)
Control valve remove + reinstall
(For exhaust side, bank 1 or bank 2)
Diagnostic Time:
10 TU
Technical diagnosis at dealer’s discretion
(Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details)
Claim Comment:
As per TSB #2041097/3
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures
Manual. Claims are subject to review or audit by Audi Warranty.
Page 3 of 4
© 2017 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Required Parts and Tools
Part Number
Part Description
Quantity
06E109257T
Control valve
1
WHT002789
O-ring
1
N 91211101
Hex socket head collard bolt
1
Additional Information
All parts and service references provided in this TSB (2041097) are subject to change and/or removal. Always
check with your Parts Department and service manuals for the latest information.
©2017 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest
information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any
time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in
any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these
materials be modified or reposted to other sites without the prior expressed written permission of the publisher.
Page 4 of 4
© 2017 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.