Service Bulletin

Service Bulletin
14-025
May 21, 2014
ATB 51252 (1405)
Driver’s Power Seat And Seat Memory Settings Do Not Work Properly
AFFECTED VEHICLES
Year
Model
2013
Accord 2-Door
2014
Accord 2-Door
2014
Accord 4-Door
2014
Accord 4-Door
2014
Accord Hybrid
2014
Accord Plug-In
Trim
EX-L V6
EX-L V6
EX-L L4
EX-L V6, Touring
EX-L, Touring
ALL
VIN Range
ALL
1HGCT2...EA000001 to 1HGCT2...EA006070
1HGCR2...EA000001 to 1HGCR2...EA179134
1HGCR3...EA000001 to 1HGCR3...EA028057
1HGCR6...EA000001 to 1HGCR6...EA005280
ALL
SYMPTOM
The driver’s power seat moves only in small increments when the switch is used. In addition, memory settings may not
work on vehicles equipped with driver position memory system.
POSSIBLE CAUSES
The driver’s power seat adjustment switch is faulty.
CORRECTIVE ACTION
Replace the driver’s power seat adjustment switch.
PARTS INFORMATION
Part Name
Part Number
Quantity
Power Seat Adjustment Switch (MSC SW UNIT ASSY)
81650-T2F-A52ZA
1
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation Number
Description
Flat Rate Time
Template ID
Failed Part Number
7491B3
Replace the driver’s power
seat adjustment switch.
0.5 hours
14-025A
81650-T2F-A51ZA
Defect Code:
03217
Symptom Code: 04201
Skill Level:
Repair Technician
REPAIR PROCEDURE
NOTE: SRS components are located in this area. Review the SRS component locations, precautions, and procedures
before doing repairs or service.
CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment,
and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not
assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact
an authorized Honda automobile dealer.
© 2014 American Honda Motor Co., Inc. – All Rights Reserved
1. Remove the driver’s seat belt lower anchor bolt.
2. Remove the driver’s seat rear foot covers and rear mounting bolts.
3. Move the driver’s seat all the way back.
4. Remove the driver’s seat front mounting bolts.
5. Disconnect and isolate the negative battery cable and wait three minutes.
6. Lift up the front seat, and then disconnect the connectors and release the harness clip.
7. Remove the driver’s seat.
8. Remove the driver’s seat front cover panel.
9. Remove the driver’s seat recline cover.
10. Remove the driver’s power seat adjustment switch knobs and remove the driver’s power seat adjustment switch.
11. Install the new driver’s power seat switch.
12. Reinstall all parts in reverse order of removal and reconnect the battery negative cable.