T-SB-0182-13

Service Bulletin Details

Public Details for: T-SB-0182-13

For vehicles that are used under certain severe operating conditions, the hv battery cooling fan may exhibit an excessive buildup of dust, lint, or other debris that can reduce the efficiency of the hv battery cooling system. Hv battery coo


- 2011 - 2010 - 2009 - 2008 - 2007 -

Models from 2011
2011 TOYOTA CAMRY
Models from 2010
2010 TOYOTA CAMRY
Models from 2009
2009 TOYOTA CAMRY
Models from 2008
2008 TOYOTA CAMRY
Models from 2007
2007 TOYOTA CAMRY
T-SB-0182-13
December 17, 2013
HV Battery Cooling Fan Maintenance for Severe Usage
Vehicles
Service
Category
Engine/Hybrid System
Section
Hybrid/Battery Control System
USA
Market
Applicability
YEAR(S)
MODEL(S)
2007 – 2011
Camry HV
ADDITIONAL INFORMATION
Introduction
For vehicles that are used under certain severe operating conditions, the HV Battery Cooling Fan
may exhibit an excessive buildup of dust, lint, or other debris that can reduce the efficiency of the
HV Battery Cooling System. HV Battery Cooling Fan maintenance and cleaning should be performed
to address this condition.
NOTE
The following procedure should be completed every 25,000 miles OR any time the HV Battery
Assembly is replaced.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
Repair Procedure
1. Is the vehicle subject to all of the operating conditions detailed below?
(1) The vehicle is used for over 15 hours per day.
(2) The vehicle is used over 6 days per week.
(3) The rear seat is used over 50 times per day.
YES — Go to step 2.
NO — This bulletin does NOT apply.
© 2013 Toyota Motor Sales, USA
Page 1 of 2
December 17, 2013
T-SB-0182-13
Page 2 of 2
HV Battery Cooling Fan Maintenance for Severe Usage Vehicles
Repair Procedure (Continued)
2. Remove the HV Battery Cooling Fan Assembly.
Refer to the Technical Information System (TIS), applicable model and model year
Repair Manual:
• 2007 (03/2006 - 10/2006) / 2007 (10/2006 - ) / 2008 / 2009 / 2010 / 2011 Camry HV:
Engine/Hybrid System – Hybrid/Battery Control System – “Hybrid Battery Control: Battery
Blower: Removal”
3. Using vacuum, and compressed air, if necessary, clean any dust, lint, or debris buildup from
the HV Battery Cooling Fan blades, module, and ducts. At this time, secure the fan blades
to prevent turning while cleaning.
Figure 1. HV Battery Cooling Fan BEFORE Cleaning
Figure 2. HV Battery Cooling Fan AFTER Cleaning
NOTICE
• Do NOT attempt to clean the HV Battery Cooling Fan while it is installed in the vehicle.
Doing so may cause dust or debris to enter the HV Battery Case.
• Failure to secure the fan blades while cleaning can result in electronic circuit failure due
to overturning.
4. Re-install the HV Battery Cooling Fan Assembly and verify normal operation.
Refer to TIS, applicable model and model year Repair Manual:
• 2007 (03/2006 - 10/2006) / 2007 (10/2006 - ) / 2008 / 2009 / 2010 / 2011 Camry HV:
Engine/Hybrid System – Hybrid/Battery Control System – “Hybrid Battery Control:
Battery Blower: Installation”
5. Repeat this procedure as normal maintenance every 25,000 miles.
© 2013 Toyota Motor Sales, USA


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.