L-SB-0088-13

L-SB-0088-13
December 3, 2013
Short Pin Installation During PDS
Service
Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
YEAR(S)
MODEL(S)
2014
CT200H
ADDITIONAL INFORMATION
Introduction
To minimize battery discharge during transportation and storage, the Short Pin has been removed at
the assembly plant and temporarily stored in the engine compartment Relay Block.
Reinstall the Short Pin and confirm all related DTCs are cleared during Pre-Delivery Service (PDS).
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
Required Tools & Equipment
REQUIRED EQUIPMENT
SUPPLIER
Techstream 2.0*
TIS Techstream
PART NUMBER
QTY
TS2UNIT
ADE
Techstream Lite
1
TSPKG1
TSLITEDLR01
* Essential SST.
NOTE
• Only ONE of the Techstream units listed above is required.
• Software version 8.30.023 or later is required.
• Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE) at
1-800-368-6787.
© 2013 Lexus, a division of Toyota Motor Sales, USA
Page 1 of 2
L-SB-0088-13
December 3, 2013
Page 2 of 2
Short Pin Installation During PDS
Short Pin Installation Procedure
Remove the Short Pin from the blank space of the Relay Block in the engine compartment and install
the Short Pin as shown in Figure 1.
Figure 1.
3
1
2
1
Relay Block
2
3
Short Pin Storage Location
Install Short Pin Here (Original Location)
NOTE
• The Short Pin does not function as a fuse, so only install it in the position shown above.
• If the vehicle is stored after PDS, disconnect the negative (–) battery terminal to prevent
battery discharge. Refer to Service Bulletin No. PG001-06, “Battery Maintenance for In-Stock
Vehicles & Pre-Delivery”.
DTC Clearing Procedure
With the Short Pin removed, the Occupant Classification ECU and Center Airbag Sensor Assembly
(airbag ECU) may detect the interruption in battery voltage (B+) and store a DTC. Clear DTCs
B1650, B1794, and U0208 after installing the Short Pin.
1. Connect Techstream to the DLC3.
2. Cycle the ignition switch to the “IG-ON” position.
3. Using Techstream, check for stored DTCs.
HINT
If any DTCs besides B1650, B1794, and U0208 are stored, repair the applicable system
according to the Repair Manual.
4. Erase DTCs (B1650, B1794, and U0208 ) and Freeze Frame Data.
© 2013 Lexus, a division of Toyota Motor Sales, USA