T-SB-0040-13
Service Bulletin Details
Public Details for: T-SB-0040-13
Some 2010 ? 2013 model year tundra vehicles may exhibit a condition where a deformed windshield dam, or some weatherstrip may be loose between the a-pillar garnish and windshield glass. Normally, the windshield dam is not visible and is onl
Models from 2013
| 2013 TOYOTA TUNDRA |
Models from 2012
| 2012 TOYOTA TUNDRA |
Models from 2011
| 2011 TOYOTA TUNDRA |
Models from 2010
| 2010 TOYOTA TUNDRA |
T-SB-0040-13 March 7, 2013 Windshield Dam Is Loose/Visible Service Category Vehicle Exterior Section Window/Glass Market USA Applicability YEAR(S) MODEL(S) ADDITIONAL INFORMATION 2010 – 2013 Tundra Plant Code(s): X WMI(s): 5TF Introduction Some 2010 – 2013 model year Tundra vehicles may exhibit a condition where a deformed windshield dam, or some weatherstrip may be loose between the A-pillar garnish and windshield glass. Normally, the windshield dam is not visible and is only necessary for production. Over time, the dam adhesive may lose adhesion and deform. There is no functional concern with the windshield sealing and there is no need to replace or reseal the windshield if there are no complaints of water/air leaks. Please follow the process below to remove the exposed portion of the windshield dam. Production Change Information This bulletin applies to vehicles produced BEFORE the Production Change Effective VINs shown below. MODEL ENGINE DRIVETRAIN PRODUCTION CHANGE EFFECTIVE VIN 5TFJU5F1#DX004830 1GR-FE 5TFRU5F1#DX028443 2WD 5TFLU5F1#DX028441 5TFJM5F1#DX001347 5TFRM5F1#DX052321 5TFEM5F1#DX052323 1UR-FE Tundra 4WD 5TFUM5F1#DX040005 5TFDM5F1#DX039993 5TFSY5F1#DX133689 5TFRY5F1#DX133688 3UR-FE 2WD 5TFFY5F1#DX133673 5TFEY5F1#DX133674 5TFLY5F1#DX133649 © 2013 Toyota Motor Sales, USA Page 1 of 4 March 7, 2013 T-SB-0040-13 Page 2 of 4 Windshield Dam Is Loose/Visible Production Change Information (Continued) MODEL DRIVETRAIN ENGINE PRODUCTION CHANGE EFFECTIVE VIN 5TFTY5F1#DX007799 5TFKY5F1#DX005557 5TFCY5F1#DX014457 5TFBY5F1#DX273419 3UR-FE 5TFMY5F1#DX273864 5TFUY5F1#DX273414 5TFDY5F1#DX273341 Tundra 5TFHY5F1#DX273340 4WD 5TFKW5F1#DX005729 5TFBW5F1#DX273441 5TFUW5F1#DX273410 3UR-FBE 5TFHW5F1#DX273297 5TFDW5F1#DX273344 5TFMW5F1#DX273987 5TFCW5F1#DX014458 Warranty Information OP CODE DESCRIPTION TIME OFP T1 T2 BD1300 Trim and Relocate Windshield Dam 0.4 90998-91004 62 14 APPLICABLE WARRANTY • This repair is covered under the Toyota Basic Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from the vehicle’s in-service date. • Warranty application is limited to occurrence of the specified condition described in this bulletin. © 2013 Toyota Motor Sales, USA March 7, 2013 T-SB-0040-13 Windshield Dam Is Loose/Visible Repair Procedure 1. Confirm that the windshield dam is loose. Figure 1.. NOTE The condition may present itself on either lower corner of the windshield. 2. Remove the front pillar garnish. A. Using a screwdriver, detach the 2 claws and remove the 2 assist grip plugs. HINT Tape the screwdriver tip before use. B. Remove the 2 bolts and assist grip. C. Detach the claw and remove the front pillar garnish. Figure 2. 1 1 Protective Tape © 2013 Toyota Motor Sales, USA Page 3 of 4 March 7, 2013 T-SB-0040-13 Page 4 of 4 Windshield Dam Is Loose/Visible Repair Procedure (Continued) 3. Using scissors or a utility knife, cut along the dashed lines shown in Figure 3. Once cut, discard the center section that was removed and tuck the loose ends back into their corresponding locations. Figure 3.. 1 1 Discard 4. Reassemble vehicle in reverse order. 5. Verify that the windshield dam is no longer visible from inside the cabin or from the outside looking in. © 2013 Toyota Motor Sales, USA