08-023-15

NUMBER:
GROUP:
DATE:
08-023-15
Electrical
March 11, 2015
This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system,
or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC.
SUBJECT:
Stored Diagnostic Trouble Codes (DTCs) Found During New Vehicle Preparation
MODELS:
2015
(BU)
Jeep Renegade (North America Markets Only)
NOTE: This bulletin applies to vehicles built for the North American Free Trade
Agreement (NAFTA) Markets only.
DISCUSSION:
DTCs are stored when the dealer technician changes the vehicle from Logistics Mode to
Customer Mode. No action is required by the technician at this time.
NOTE: Stored DTCs will auto erase after 40 plus ignition key cycles.
NOTE: Any time the vehicle changes from Logistics Mode to Customer Mode DTCs
are stored.
SYMPTOM/CONDITION:
Stored DTCs will vary based on vehicle configuration, below is a list a Stored DTCs that
may be found on a typical vehicle.
Module
DTC
Message
AMP
U2007-64
Message STATUS_TELEMATIC.AUDIOSts_Telematic (from
Entertainment Telematic Module) - Signal plausibility failure
AMP
U2001-87
Message CTRL_AMP (from Entertainment Telematic
AMP
U2021-87
Message STATUS_TELEMATIC.CurrentSource (3) (from
Entertainment Telematic Module) - Missing message
AMP
U1736-87
Entertainment Telematic Module (ETM / LTM) - Missing
message
AMP
U2018-64
ETM Current Source 1 = SNA
AMP
U2019-64
ETM Current Source 2 = SNA
BCM
U1736-87
LTM (LowLevel Telematic Module) / ETM (Entertainment
08-023-15
-2Telematic Module) - Missing message
BCM
U0254-87
Lost Communication With Remote Start Module - Missing
message
BCM
B10AA-4A
Configuration mismatch
ETM
B1562-13
GPS antenna open
ETM
B2206-00
Current VIN Missing / Mismatch
ETM
U1193-87
Loss of communication with LBSS
ETM
U1194-87
Loss of communication with RBSS
ETM
U0422-86
Invalid data received from BCM
RFHM
U197C-83
CRC and Message Counter TRANSM2 - Value of signal
protection calculation incorrect
RFHM
B1033-64
Operational Mode Status 1 - Signal plausibility failure
POLICY:
Information Only