08-025-15

NUMBER:
GROUP:
DATE:
08-025-15
Electrical
March 12, 2015
This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system,
or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC.
HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS
AVAILABLE BY SELECTING “HELP” THEN “HELP CONTENTS” AT THE TOP OF
THE wiTECH DIAGNOSTIC APPLICATION WINDOW.
THE wiTECH SOFTWARE LEVEL MUST BE AT 15.03 OR HIGHER TO PERFORM THIS
PROCEDURE.
SUBJECT:
Flash: Auto Lock Feature Inoperative
OVERVIEW:
This bulletin involves updating the Cab Compartment Node (CCN) software.
MODELS:
2015
(MK)
Jeep Compass/Patriot (China Market Only)
NOTE: This bulletin applies to vehicles built on or before February 05, 2015 (MDH
0205XX) equipped with Speed Sensitive Power Locks (Sales Codes JPH).
SYMPTOM/CONDITION:
The customer may notice that the power door lock will not auto lock when the vehicle
starts moving forward.
DIAGNOSIS:
Using a Scan Tool (wiTECH) with the appropriate Diagnostic Procedures available in
TechCONNECT, verify if any Diagnostic Trouble Codes (DTCs) are set. If DTCs are
present, record the issues on the repair order and repair as necessary before proceeding
further with this bulletin.
If the customer describes the symptom/condition listed above, perform the Repair
Procedure.
REPAIR PROCEDURE:
NOTE: Install a battery charger to ensure battery voltage does not drop below 13.2
volts. Do not allow the charging voltage to climb above 13.5 volts during the
flash process.
NOTE: If this flash process is interrupted/aborted, the flash should be restarted.
08-025-15
-2-
1. Reprogram the CCN with the latest available software. Detailed instructions for
flashing modules using the wiTECH Diagnostic Application are available by selecting
the “HELP” tab on the upper portion of the wiTECH window, then “HELP CONTENTS.”
This will open the Welcome to wiTECH Help screen where help topics can be
selected.
2. Clear any DTCs that may have been set in any modules due to reprogramming. The
wiTECH application will automatically present all DTCs after the flash and allows them
to be cleared.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation
No:
18-19-45-9J
Description
Module, Cab Compartment Node
(CCN) - Reprogram
(0 - Introduction)
Skill Category
6 - Electrical
and Body
Systems
Amount
0.3 Hrs.
NOTE: The expected completion time for the flash download portion of this
procedure is approximately 9 minutes. Actual flash download times may be
affected by vehicle connection and network capabilities.
FAILURE CODE:
FM
Flash Module