LTB01204NAS1
Service Bulletin Details
Public Details for: LTB01204NAS1
6/11/2018 LTB01204NAS1 - Engine MIL Illuminated With DTC P0234-77 Stored | TOPIx LT B 0 1 2 0 4 N A S 1 TECHNICAL BULLETIN 11 JUN 2018 © Jaguar Land Rover North America, LLC NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Land Rover service facility to determine whether this bulletin applies to a specific vehicle. I N F O R M AT I O N SECTION: 303-04: Fuel Charging and Controls S U B J E C T/ C O N C E R N : Engine MIL Illuminated With DTC P0234-77 Stored AFFECTED VEHICLE RANGE: MODEL: MODEL YEAR: VIN: ASSEMBLY PLANT: APPLICABILITY: Range Rover Sport (LW) 2016 519971-599874 Solihull TDV6 3.0L Diesel Range Rover Sport (LW) 2016-2018 617562-699492 Solihull TDV6 3.0L Diesel Range Rover Sport (LW) 2016-2018 100369-199996 Solihull TDV6 3.0L Diesel https://topix.jaguar.jlrext.com/topix/content/document/view?id=901894 1/6 6/11/2018 LTB01204NAS1 - Engine MIL Illuminated With DTC P0234-77 Stored | TOPIx MODEL: MODEL YEAR: VIN: ASSEMBLY PLANT: APPLICABILITY: Range Rover Sport (LW) 2018 Onwards 400291 Onwards Solihull TDV6 3.0L Diesel Range Rover Sport (LW) 2018 Onwards 800063 Onwards Solihull TDV6 3.0L Diesel Range Rover (LG) 2016-2018 216967-399999 Solihull TDV6 3.0L Diesel Range Rover (LG) 2018 Onwards 500017 Onwards Solihull TDV6 3.0L Diesel MARKETS: NORTH AMERICA CONDITION SUMMARY: SITUATION: The engine Malfunction Indicator Lamp (MIL) may be illuminated on the Instrument Cluster with Diagnostic Trouble Code (DTC) P0234-77 stored in the Powertrain Control Module (PCM). DTCs P2463-00 and P246B-00 may also be stored. CAUSE: This may be caused by a component fault. ACTION: Should a customer express this concern, follow the Diagnostic Procedure and Workshop Procedure(s) below. PA RTS : PART NUMBER DESCRIPTION QUANTITY LR078546 Intake air shutoff throttle 1 LR063121 Inlet hose clamp 1 https://topix.jaguar.jlrext.com/topix/content/document/view?id=901894 2/6 6/11/2018 LTB01204NAS1 - Engine MIL Illuminated With DTC P0234-77 Stored | TOPIx TOOLS: Jaguar Land Rover-approved Midtronics battery power supply Jaguar Land Rover-approved diagnostic tool with latest SDD Software Management Pack 95-0106 Jaguar Land Rover-approved diagnostic tool with latest PATHFINDER software High Pressure Diagnostic Leak Detector WARRANT Y: NOTES: Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to JLR claims submission system to obtain the latest repair time. The JLR Claims Submission System requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero. DESCRIPTION SRO TIME (HOURS) CONDITION CODE CAUSAL PART Leakage test using smoke test equipment 01.01.28 0.4 41 LR078546 Read and clear Diagnostic Trouble Codes (DTC's) 12.90.16 0.2 41 LR078546 https://topix.jaguar.jlrext.com/topix/content/document/view?id=901894 3/6 6/11/2018 LTB01204NAS1 - Engine MIL Illuminated With DTC P0234-77 Stored | TOPIx DESCRIPTION Intake air shutoff throttle - Renew TIME (HOURS) SRO 19.70.32 0.5 CONDITION CODE 41 CAUSAL PART LR078546 NOTE: Normal Warranty procedures apply. DIAGNOSTIC PROCEDURE: CAUTIONS: A Jaguar Land Rover-approved Midtronics battery power supply must be connected to the vehicle startup battery during diagnosis / module programming. All ignition ON/OFF requests must be carried out. Failure to perform these steps may cause damage to control modules in the vehicle. 1 Connect the Jaguar Land Rover-approved Midtronics battery power supply to the vehicle startup battery. 2 NOTE: The Jaguar Land Rover-approved diagnostic tool must be loaded with SDD153.04 Software Management Pack v296 (or later) OR PATHFINDER 164 (or later). Connect the Jaguar Land Rover-approved diagnostic tool to the vehicle and begin a new session. 3 Follow all on-screen instructions, allowing the diagnostic tool to read the VIN, identify the vehicle, and initiating the data collect sequence. 4 Read the Diagnostic Trouble Codes (DTCs). If DTC P0234-77 is stored, go to Workshop Procedure 'A'. https://topix.jaguar.jlrext.com/topix/content/document/view?id=901894 4/6 6/11/2018 LTB01204NAS1 - Engine MIL Illuminated With DTC P0234-77 Stored | TOPIx If DTC P0234-77 is not stored, do not continue with this Technical Bulletin. Perform diagnosis as per TOPIx Workshop Manual section 100-00: General Information - Description and Operation. 5 Exit the current session. 1 Select the Session tab. 2 Select the Close Session option. WORKSHOP PROCEDURE 'A': NOTE: Diagnostic Trouble Code (DTC) P0234-77 can be attributed to a leak in the air intake system. 1 Complete a leakage test on the intake system using smoke test equipment (see TOPIx Workshop Manual section 303-00: Engine system general information - General procedures Leakage test using smoke test equipment). If a leak is not found, go to Service Instruction B. If a leak Is found, repair as required (see TOPIx Workshop Manual). To be performed as a separate claim. When the leak repair is complete, go to the next step. 2 NOTE: The Jaguar Land Rover-approved diagnostic tool must be loaded with SDD153.04 Software Management Pack v296 (or later) OR PATHFINDER 164 (or later). Begin a new session. 3 Follow all on-screen instructions, allowing the diagnostic tool to read the VIN, identify the vehicle, and initiating the data collect sequence. https://topix.jaguar.jlrext.com/topix/content/document/view?id=901894 5/6 6/11/2018 LTB01204NAS1 - Engine MIL Illuminated With DTC P0234-77 Stored | TOPIx 4 Read and clear all Diagnostic Trouble Codes (DTCs). 5 Retest the vehicle. 6 After the retest, read the DTCs. If DTC P0234-77 is not stored, do not continue with this Technical Bulletin. Go to the next step. If DTC P0234-77 is stored, go to Service Instruction 'B'. 7 Exit the current session. 1 Select the Session tab. 2 Select the Close Session option. 8 Disconnect the diagnostic tool and battery power supply from the vehicle. WORKSHOP PROCEDURE 'B': 1 Replace the intake air shutoff throttle (see TOPIx Workshop Manual section 303-04: Fuel Charging and Controls - Removal and Installation - Intake Air Shutoff Throttle). https://topix.jaguar.jlrext.com/topix/content/document/view?id=901894 6/6